First off;  THANK YOU N26 for ScratchPad



This procedure uses VoiceAttacks Dictation Buffer and Speech-to-Text functionality to type out what you dictated.
With the ScratchPad up and in focus, you can use VoiceAttack to TRANSCRIBE your dictation. 


This system requires that the ScratchPad window position is always the same.  
The current rendition is based on the scratch pad centered on the monitor, but can easily be changed to suit (see below).

Here's how it goes.

Say BEGIN DICTATION
Listen for audio confirmation then start dictating.

Say END DICTATION
       
Say SCRATCHPAD 
Brings up Scratchpad in focus.

Say TRANSCRIBE
Data prints out on Scratchpad

Say ESCAPE
Brings focus back to DCS but preserves ScratchPad overlay

Say FOCUS SCRATCHPAD 
Puts ScratchPad back in focus and ready to recieve additional transcription

Say CLEAR SCRATCHPAD
Clears ScratchPad.
            
Say CLEAR DICTATION
Clears the Dictation Buffer

Say SCRATCHPAD
Toggles overlay off



NOTES:

If you want to hear an audio version of what you dictated, Say PLAYBACK (instead of TRANSCRIBE).
The Dictation Buffer playback will be Looped 10 times or untill you Say ENOUGH. 
Say CLEAR DICTATION to clear the Dictation Buffer.

The Speech-to-Text function can get a little wonky but with a liitle practice it does fine,
and any typos are usually inconsequential.  After all, It's a ScratchPad DAMMIT!!!

The ScratchPad always loads to the same position.
To reposition your Scratchpad, drag & size it where you want it, then edit these VA commands;
SCRATCHPAD, CLEAR SCRATCHPAD, FOCUS SCRATCHPAD.
Specically, change the "Move mouse to Primary Screen Center" action to the new location using the move mouse tool.

If you use the TRANSCRIBE command without the ScratchPad open, key presses will reach DCS.
Ex: If the transcription included the "F" key, Your Huey will shut down (F=Fuel cutoff)