All Activity

I had someone hop in my front seat after I had been flying for a bit last night without a crash. This was in a hot-start aircraft. Are you seeing this with hot-start, cold-start, or both?

If DCS is started with the device the modifiers is created with/for not connected, the modifiers get deleted

- a missed word in the briefing left section (under the pictures): "...destroyed fighting [positions]..." - AWACS is on CH 6 but CH 7 is marked in the kneeboard - KC-135 with TACAN from the kneeboard is about 100 nm east of the drop zone (unless it's intentional or historically accurate) - the carrier turned while the plane was in the groove (though it might happen outside the expected recovery time slot after going to the distant tanker and back) P.S. Thanks for the campaign! Realistic and fun but forgiving

Are other Jester commands working? Other wepon types etc? Nothing was changed in the AIRIO module so it should operate the same. Also try cycling AIRIO off the rerstarting Voice Attack Then Back on and restarting. also check Use Appensicies is checked. I'll be traveling for a few days if you still have issues jump onto our Discord for support. nullnull

I guess at CW peak in the 80ties Europe was full of military bases, baracks, airports, launch ramps, naval, radar stations, hidden bunkers ect. all over, east and west. Including them all, even just the major ones into CW Germany map would blow it up to several hundred GB if not TB and probably too large to handle.

I would say that the auto update is not downloading? when you accept the update offer on the popup do you see in yellow in the Voice Attack window Doenloading then installing befor Voice Attack retarts?

Does anyone have the profile for F-22? I have tried searching and am not having any luck with it.

I sure hope that PTO goes well for Eagle Dynamics, that would greatly increase the chance that we might get a map like this one pictured.

Solved it!! I set up in Pimax play at 90hz but launch striaght from DCS... On my DCS settings... slid the FPS units down to 70fps...... everything on most maps no longer has stutters nor blurs Maps Like Germany, Marianas still have them as Im not sure they are optimised yet for VR... Now I can fiinally say WOW

How did you get to those missions? Are these your missions? Because all the missions have baked-in views, so yes, they will NOT WORK as expected: I started DCS, opened the Mission Editor, created a new Marianas mission, put MiG-15 there, skill Player, saved. No baked in views. Something must have happened to put them there. Try to do this minimal mission and look into the miz file. Mine looks like this: As you can see, no Config subdir there. I'd like to help you, or at least say "I don't know how to, problem is somewhere else", but you have to stop complaining about the mission with baked-in views. They will NOT work with your snap views. As I said above, first things first, be SURE the mission does NOT have baked-in views. Otherwise, we're wasting everybody's time - yours included. Then we can figure out what else is wrong. E.g. how did the config/views appeared there. Or if it's not there, what else doesn't work. Right now we haven't moved from square one. Always follow the evidence. Otherwise things get confusing.

OK updated to latest hotfix. Ive found my problem with stutters and blurs!!! I have set up in Pimax play at 90hz but launch striaght from DCS... On my DCS settings... slid the FPS units down to 70fps...... everything on most maps no longer has stutters nor blurs Maps Like Germany, Marianas still have them as Im not sure they are optimised yet for VR... Now I can fiinally say WOW

still happening

Yes Ive just found how to clear them!!! set up in Pimax play at 90hz but launch striaght from DCS... On my DCS settings... slid the FPS units down to 70fps...... everything on most maps no longer has stutters nor blurs Maps Like Germany, Marianas still have them as Im not sure they are optimised yet for VR... Now I can fiinally say WOW

Yes

This would be awesome especially if we could add voices.

I think I have found a temporary workaround to this issue, at least until ED notices / reads this thread and hopefully fix this issue..... I have marked the file SnapViews.lua as "read only", and it seems to work with all my WWII Marianas Corsair missions, and even in the training missions. Oddly enough, the 3 miz in the included zip still present the wrong level the zoom level of the default front view, and in spite of the as "read only" status of the SnapViews-lua I can still after a few tries change in that default front view the zoom level, but then other views get busted. Well, less important, as long as the corsair missions work, those should be in the WWII Marianas map... Again, MIG-15, 19 and Sabre on maps other than the Marianas, no issues at all... Go figure.... REALLY? Nobody experience a similar issue? ED? signs of life? Still-Busted.zip

Not using FPS limiter (meaning value above 120) in DCS helped looking left and right without stutters in my case

LOL

Судя по тому видео и видимой разметке полосы, экипаж уложился в 750 метров посадочной дистанции, считая от рабочего порога. Это может означать примерно 1500 метров потребной, при благоприятных условиях.

Okay. I have no more questions.

Moin Hab hier noch nen VKB Gunfighter MK2 mit MCG (Modern Combat Grip) ohne Z-Achse (kann nachgerüstet werden), Base, Blackbox, diverse Federn/Cams und 100mm Verlängerung. Montiert ist die Feder passend zur Extension. Ist gebraucht, aber gut in Schuss. Blackbox könnt ihr Aussuchen ob die Rote oder die erste Schwarze. 200 Euro inkl. Versand

bon jour again check this video. null