SsgtHolland

+1 This would make the setup for Voice Attack much easier. Things that would be helpful in this regard: Shortcuts for CP/G weapon selection i.e. WAS Hellfire, WAS Gun, WAS Rockets Commands for George pilot to fixed altitudes i.e. Altitude 50 feet, Altitude 100 feet, Altitude 500 feet Commands for George Pilot to change heading is set increments i.e. Left 20, Left 45 Commands for George pilot to set cardinal directions i.e. Heading West, Heading North East Commands for George pilot to transverse forward/ sideways a set distance when hovering i.e. Left 20 meters, Forward 100 meters

You get the full coordinate, including UTM zone reference on the knee board page in this format? 36SAB12349876

Yes, definitely +1!

More control over monocle appearance would be nice! Especially controls for positioning closer or further away, without using zoom. I would also like a transparency slider

Knee board TSD points that are provided in missions are missing UTM zone reference like 36 S /37 S. This can be inconvenient for maps that span multiple UTM zones like Caucasus, Syria and Persian Gulf.

In the supplied TSD points at mission start, the MGRS coordinate for the BP is missing the 100 km grid letters. Also MGRS is misspelled. AH-64D Ghost Farp coordinate Error.trk

Maybe it's possible to let George CP/G WAS up weapons, even if they are out of ammo. But add voice message "Winchester Hellfire/Rockets/30 Mike Mike"

Yes, I tried, but George was stuck on rockets. Maybe because that was the only weapon ammo left.

After WASing up rockets in CP/g seat, when switching to pilot seat and WASing rockets, it is not possible to get out of coop mode for rockets. This happened with only rockets remaining as ammunition. After deslaving CP/G George, the pilot has no command over rocket steering cue and coop remains in HDU.

Programming the flaps switch in TARGET Hey DM(cool handle, great album!) I just got the TM WH and I struggled with the exact same thing. It seemed like there was a keycommand missing in the control options. The solution is to do the programming in TARGET. Start by assigning the 'F' key to the flaps down part of the switch in TARGET. Then assign the 'L-Shift+F' to the flaps up part of the switch. Now for the solution to the mvr problem. We need to set up the mvr part of the switch, so that it sends an up-command when coming from the down position and a down-command when switching from the up-position. To do this, you need to use the release function in TARGET. On the flaps up part of the switch,assign the flaps down key and program this to release instead of press. Do the same for the downpart of the switch, assign a flaps up command to the switch with a release setting. I also linked a led on command to the flaps up release parameter. The led off command is linked to the flaps up state of the switch. And that's it!