Sarge55

That is strange. Are they still visible on the in game MFD's? Try running a repair and see if that fixes it first. Perhaps your CPG.lua is mucked up. Otherwise, if you want to fly you may have to create a PLT.lua, unfortunately that would not allow you to swap seats in game as you would end up with the pilot displays in the front seat.

Mission planner and DTC, is to dream I think. Still on the back burner... sigh.

The answer is DTC / mission planning should have been implemented years ago. And yet, it continues to be put on the back burner.

There is an OVGME mod for this. Unfortunately I’m not at home or I would give you a link. i did find it in the forum though, try a search in the bugs thread.

Looking forward to Lines being implemented. I like putting in the FLOT and “kill boxes” for better SA. Even better will be when we get the DTC and mission planning

Only other thing I can think of is have you set the resolution in options to the full size of both monitors? I run two monitors (set side by side resolution wise) so my in games options resolution is 4620x1080.

Just looked at the posted Lua and it is for a single monitor not a second monitor. The exports look to be set to appear on the bottom, offset L&R from the center on the main display. Unless I'm misreading it.

Looks like good set of missions. Give it a go shortly.

Yes

Anyway to set it back to GS?

My order is in as well. Really looking forward to getting these setup.

I’ll have to give it a try.

Thanks Horus.

Thanks dburne. So the extension allows you to angle the stick while the base stays straight. Nice. I have the same pedals, they are great.

Could you elaborate on this? No idea how that works, perhaps you could provide the Lua file and where it goes?

When centre mounted do you have the stick turned on an angle (15 degrees) or do you have to bend your wrist to hold it? If you angle it, how do you calibrate it?

Trim reset was a great addition alright Devrim.

Give this video from Casmo a watch. He explains how to set up the manual and auto ranging but more importantly why it will return to default range after setting the A auto range.

I think it is "correct as is", the digital read-out ends at 9999. They are not saying the laser beam is ending at 9999 m, it still goes on for a distance. That is how I understand it.

Thanks Floyd, me to. I should take this to the F-16 thread rather than clutter up the Apache thread.

Perhaps someone can point me in the right direction on something. I jumped back into the Viper and turned on re-shade and the MFD's were great, lettering and lines were very clear and easy to see just like my quick test earlier getting the Apache sorted. This time however, since I was flying a training mission I activated A/G mode and brought up the TGP and A/G radar both of them were very bright and completely washed out. The text around the outside was still somewhat visible but faint and the lines (crosshair or sweep line) were invisible due to the brightness of the background. Now the problem, when I turn down the brightness to be able to see the images the text and lines fades away almost completely. I tried to adjust the gamma in Re-shade, it adjusted the image fine but the letters and lines also became faded as well. Is there a setting which affects the text and lines? Adjusting SYM or CONT rockers seemed to have no effect on the text or lines. This was not the case with the Apache, I had to tone VID down a little but all the text stayed as is. Any suggestions?

Any news on the Pre-purchase?

I think I’ve seen that somewhere. Now where was that? In an old 1990’s sim I think

If he doesn’t fire I find that I’m not oriented on the target correctly or dropped too low. Once I sort that out he happily fires away.

I didn’t realize RAZBAM produced Hornet campaigns. Which one is it?