borisff

Nice, congrat. I'm curious how you beat gravity and make the lever stay where it is and at the same time keep it smooth movable? (except if you simply use the 'force' like a Jedi, I tried, but I can't). This build use a friction

https://forums.eagle.ru/showpost.php?p=4407482&postcount=163 may help...

Used saturation at 80% for throttle, this allows now a zero colective. And now Minister is on board in 5 seconds, no need to go to idle. Many Thanks !!! Would suggest to add an image like previous post col1.JPG to the images of Mission 01 and write in the briefing "Land close in front of CH-130 nose and be sure collective is fully down (check with control helper). There are probably a few more brainless Peter P like me around...

Hum, attached the minimum collective I can get with a CH pro USB throttle, hit Num- changes nothing, doesn't go lower(col2.JPG). When remove the USB Throttle, Num- allows to go lower, up to zero (col1.JPG). There is a difference, but isn't a problem in KA50/MI8 various campaings completed. Have no idea how to change that expect unplug the USB throttle after Landing.

Similar problem, tried 4 times, and gave up this campaign. Read somewhere that engine has to be set on 'idle' after landing near CH-130 , if it's the case, it's a pity that is not written explicitly in the Briefing, as we can't read the triggers ourselves...

VampireNZ link allows to keep left control helper and remove right one, perfect. Thanks. Cool would be to able to change com menu colors, though.

Hi, can't read the com menu list because autopilot window. How can I remove autopilot window or change com menu colors ? Thanks

Having following problem with ch pro throttle Afterburner switch is off, Emergency AFB switch is off move throttle full with ch pro throttle AFB light is off Afterburner switch on The throttle moves one notch more by itself and AFB light is on Until this point seems ok. Then Emergency AFB switch on No Emergency AB light, i have to press NumPAD + key The throttle moves one notch more by itself and emergency AFB light is on Throttle back, Emergency AFB switch off, Afterburner switch off and then same behavior when doing from begin. In a nutshell, I can't get EAFB on without having to add a NumPAD+ key ch pro throttle calibaration seem to doesn't matter, moving stick to 90% only as end point, same behavior. https://www.youtube.com/watch?v=gaMpyEuhUZw

Serious FPS drop, each time AAA fires, even far away, even if not looking at it

In this screen

My joystick is a MS sidewinder FB 2. In some DCS modules, swap axis in FF tune must be on for this joystick. For the 109, seems should be off. Anyone ?

Afterburner toggle on/off Emergency Afterburner toggle on/off

Request for a few added default keymap for mig 21, for those who have few joystick buttons, to avoid http://forums.eagle.ru/showthread.php?t=124480 Airbrakes toggle on/off Afterburner toggle on/off Emergency Afterburner toggle on/off

Repair. Stick will only be an inch higher. I've found how to remove motors plate (didnt see the screw deep in each white plastic leg :music_whistling:). Than simply dremel the broken stick base , drill a 12mm hole and use a 12 mm alu tube. Thanks

and to remove the broken plastic tube, I have to cut these wires and push it out from inside using a 13/14mm rod right ?