tsohg2701

Hello all ! Having all the above issues with 2.7 update. Now, when clicking on options to go to setting, this open up on main monitor and unable to see anything. how do I go back to DCS setting to select my .Lua ,thank you for help ! update: able to return back into options menu and accessed my Lua, however , issues with 2.7 update still exists with regard to 3 monitors resolutions setup.

Yes I did .... with the help and support from DCS Sim community , everyone here is so helpful...thank you !

Sabre-Ewan, your 100% right on. Virpil joystick/base tutorials : Thank you all for helping !

found some YouTube tutorial regarding creating Virpil profile for the grip, will update , thank you all for helping !

Sabre-Ewan, no I have not created a profile with the grip. Thought I am able to assign funtions w/ DCS. Can you point me in the right direction regarding this. Much appreciate all for the help !

Update: As per Ashaya / Lange-666"s direction, I am able to confirm a 100% solid connection. Able to have the TM cougar grip connected to Virpil S-short extension seated to the TM Hotas Magnetic Base, works perfect. Did the dance : plug and unplug, restart CPU, restart DCS, seat and unseat the grip... Still not working with Virpil Base. Virpil software does not see any TM grip buttons when testing. Thank you for your help !

Yes, DCS setup menu sees Virpil. Tried to reseat many times carefully. The design makes it difficult to confirm a proper connection. Should I pull the cable out , reconnect then seat the grip to base ? But if DCS sees Virpil, does it not indicate a firm connection/ seating ? Seems like DCS confirmed the presence of the Virpil base but not the cougar grip connecting to the base. Also, tried to connect Virpil short S-extension to TM cougar grip and seat to TM Hotas Magnectic base, DCS does not confirm the cougar grip. Thank you for your help !

Just received my Virpil VPC MongoosT-50CM2 Base today. Tried to install my Thrustmaster Cougar's grip, but its not working. DCS only sees X and Y axis, but unable to program/ assign any other buttons/funtions to the Tm cougar grip, not sure what I am doing incorrectly. ( cougar grip works fine with TM Hotas Magnetic Base ) Need assistance, thank you !!!!!

Extract the cat? that's my fly buddy, miss Belle...always sits there when I am flying ! picture of 3rd right monitor : 3 inches black bar on right thank you so much for your help !

LeCuvier : Adjusted x and y values as per your advice... thank you so much for taking the time to assist me with DDI extractions . You're the man Lecuvier !! Questions: 1) how to adjust the F18, it is now off center ( to the left) as you can see in the picture. 2) on my 3rd main monitor, there a black bar going down on far right,3 inches wide ( tried to adjust the total resolutions of the 3 main monitors in Sim setting, but unable to expand ) 3) HUD symbology , lines and numbers thicker and not as defined as in the DDI otherwise, its all good . Once again Thank you for your help !

yes, 8560 x 2040 Resolution in DCS still unable to see my saved Lua file in DCS to test all this out. Try to search in forum but having not luck. thank you for your help !

removed " / " adjusted x,y values In DCS option menu : resolution : 8560 x 2040 aspect ratio: 4.1960784313725 saved lua file name is the same DCS not seeing lua file still. thank you for your help !

Can someone please check and verify my Lua file values, and also DCS not seeing saved Lua in option pull down menu. Thank you and merry Christmas !

LeCuvier, sorry I failed to mentioned my setup upgraded to a 5 monitors thus the changed in values. My bad !