LED Interface

[Ditch3r]

First off, hello all, it's been a long time since I've been here on the forums. However, I'm back and into pit building. I've been making great progress thanks to the unbelievable amount of information so many have shared here. I really can't thank this community enough.

 

Now to my problem.

 

I have an Arduino UNO hooked up and reading in Helios under a EOS Bus. All is good, I see the three LED's I have hooked up and the code is working good. I can toggle them on and off with a toggle switch set up in Helios.

 

However, I would like to link these to specific indicators so that when a light comes on in the simpit I get the light on my board. I have put indicators on my Helios screen but there is no output option for them, what am I missing?

 

On a side note, I was able to get these indicators to light up using a UDP bridge, and running the simulator. However, I would like it all to run through Helios if possible being I already need it for my other displays.

 

I look forward to hearing from you, and I'll get get a pit building thread started here soon. :)

 

EDIT:

Shortly after posting this I figured out how it works. I wasn't aware that you had to have the EOS Bus tab open and link it through the bindings that way! Hopefully this will help someone else out along the way.

Edited December 18, 2014 by Ditcher
Figured it out...

[[FD]Ripper]

Ditcher, what is the maximum number of LEDs can be used with the Arduino UNO? Can show us an example of your code?