Darkwolf Posted September 1, 2015 Share Posted September 1, 2015 Hello everyone. I haz a problem in su-25t, which also has been reported by other member of my squadron. the HUD heading info isn't correct. It shows different value in NAV and in Attack mode (7). This happen every flight so it shouldn't be hard to reproduce. My apologies if this has already been reported. [sIGPIC][/sIGPIC] PC simulator news site. Also....Join the largest DCS community on Facebook :pilotfly: Link to comment Share on other sites More sharing options...
kontiuka Posted September 1, 2015 Share Posted September 1, 2015 I just tried this and didn't see a problem. Are you guys using any mods that might cause this? Link to comment Share on other sites More sharing options...
Skjold Posted September 1, 2015 Share Posted September 1, 2015 I had my HUD heading show 120 degrees off the other day, no mods at all. It normally works tho, it was a one-off thing. Link to comment Share on other sites More sharing options...
kontiuka Posted September 1, 2015 Share Posted September 1, 2015 ok. I see it. When you are flying straight and level you don`t notice it. When you are in a turn and switch between ground attack and nav modes, you`ll see the HUD heading tape jump a few degrees. Link to comment Share on other sites More sharing options...
Mustang Posted September 1, 2015 Share Posted September 1, 2015 After starting systems from cold start (right shift L) allow at least 3 mins for INS alignment otherwise this problem will occur. Link to comment Share on other sites More sharing options...
Frostie Posted September 1, 2015 Share Posted September 1, 2015 Yes if you move off the ramp too soon your HSI will be bent. "[51☭] FROSTIE" #55 51st PVO "BISONS" Fastest MiG pilot in the world - TCR'10 https://100kiap.org Link to comment Share on other sites More sharing options...
kontiuka Posted September 1, 2015 Share Posted September 1, 2015 I saw the problem starting in-flight. Link to comment Share on other sites More sharing options...
Recommended Posts