Jump to content

Hall Sensors used by CubPilot-Cougar


Recommended Posts

Gents:

 

I received a schematic of the Hall Sensor allegedly used in the Uber II Nxt gimbals... But neither the schematic nor the U2 material I have state the

diameter, depth of the larger whole which the Hall screws into and the width and depth of the hole the single rod goes into... You can tell and see the small hole is machined to allow the shaft to fit in securely without play... but the units .. the Halls are $100.00 each plus shipping...

 

Rolan d

Link to comment
Share on other sites

Midori QP-2H/2HC PDF say 3mm for axis diameter:

http://www.midori.co.jp/e_pdf/orange/006-007-QP-2H-QP-2HC.pdf

 

This picture (Cougar Word) show one these sensor (pre Uber NXTII kit) with bushing on axis to match original potentiotemer axis diameter. This kind of potentiometer have a ~5/6mm diameter axis.

 

http://cougar.flyfoxy.com/images/cougar/Hall_and_OEM_pots.jpg

 

You need find a way to measure his Uber NXT mounting hole, what is not difficult using a caliper.


Edited by Sokol1_br
Link to comment
Share on other sites

  • 4 weeks later...
Gents:

 

I received a schematic of the Hall Sensor allegedly used in the Uber II Nxt gimbals... But neither the schematic nor the U2 material I have state the

diameter, depth of the larger whole which the Hall screws into and the width and depth of the hole the single rod goes into... You can tell and see the small hole is machined to allow the shaft to fit in securely without play... but the units .. the Halls are $100.00 each plus shipping...

 

Rolan d

the pics you mentioned shows the modifications needed to fit them on the stock gimbals.

Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...