DMZ zone changes when changing radar range

[il_corleone]

Hello,

When locking a target, if you change from 80, to 40 and 20, the DMZ zone changes,not in a normal behaviour of space, it changes the amount of nm

 

At long range, it says max range is 30nm, but if you got less range, it says max range is 10nm.

 

Dont know if is a bug

[Elo001]

Hello,

When locking a target, if you change from 80, to 40 and 20, the DMZ zone changes,not in a normal behaviour of space, it changes the amount of nm

 

At long range, it says max range is 30nm, but if you got less range, it says max range is 10nm.

 

Dont know if is a bug

 

Does this impact actual missile performance? Cause that'd be hilarious

[OnlyforDCS]

Does this impact actual missile performance? Cause that'd be hilarious

 

No it doesn't. The DLZ actually stays the same, the scale changes just like on the radar screen. I don't think is a bug.

[LFCChameleon_Silk]

DLZ changes based on scale of radar and is not a bug

 

if your displaying to 80nm the DLZ cues will be further near the bottom since the full length of the line is 80nm, where if it were set to 40 the the cues would be further toward the middle.

[diditopgun]

Hello,

When locking a target, if you change from 80, to 40 and 20, the DMZ zone changes,not in a normal behaviour of space, it changes the amount of nm

 

At long range, it says max range is 30nm, but if you got less range, it says max range is 10nm.

 

Dont know if is a bug

 

Yes I see this DLZ behavior too.