kashmir Posted December 15, 2016 Posted December 15, 2016 This is the first time I have seen this. While trying to program WP2 I was greeted by the gibberish in the screenshot. The gibberish was present no matter what parameter I was on. WP1 & WP0 showed up with no issues, but as soon as I set DEST or PREP to 02, I had this issue. I couldn't enter data on either block. I had no issues with alignment and I was able to still operate the aircraft just fine using WP1. The next time I got into the cockpit the issue was gone and has not popped up again. Fluke? [sIGPIC][/sIGPIC]
myHelljumper Posted December 15, 2016 Posted December 15, 2016 I can confirm this bug, I don't know what is the cause. Helljumper - M2000C Guru Helljumper's Youtube https://www.youtube.com/channel/UCK3rTjezLUxPbWHvJJ3W2fA
CrashO Posted December 15, 2016 Posted December 15, 2016 I have seen this too, but only in a "dirty" plane. Seems there is some data being left in the memory. -> enter new game session, pick mirage startup, enter a couple of waypoints, no problems # get shot, pick the same mirage again startup, and look at waypoint 1, and data from the last time still seems present (it is showing the old entered coordinates, so are 2 and 3 etc. However, I can only select them in PREP, not use them in DEST. When I try to change them, sometimes the fluke from the OP happens. However, It is possible to enter a new waypoint over it, you just have to do it "blind". After entering, the screen is normal again.
myHelljumper Posted December 15, 2016 Posted December 15, 2016 I have seen this too, but only in a "dirty" plane. Seems there is some data being left in the memory. -> enter new game session, pick mirage startup, enter a couple of waypoints, no problems # get shot, pick the same mirage again startup, and look at waypoint 1, and data from the last time still seems present (it is showing the old entered coordinates, so are 2 and 3 etc. However, I can only select them in PREP, not use them in DEST. When I try to change them, sometimes the fluke from the OP happens. However, It is possible to enter a new waypoint over it, you just have to do it "blind". After entering, the screen is normal again. Nice finding. Helljumper - M2000C Guru Helljumper's Youtube https://www.youtube.com/channel/UCK3rTjezLUxPbWHvJJ3W2fA
kashmir Posted December 15, 2016 Author Posted December 15, 2016 I have seen this too, but only in a "dirty" plane. Seems there is some data being left in the memory. -> enter new game session, pick mirage startup, enter a couple of waypoints, no problems # get shot, pick the same mirage again startup, and look at waypoint 1, and data from the last time still seems present (it is showing the old entered coordinates, so are 2 and 3 etc. However, I can only select them in PREP, not use them in DEST. When I try to change them, sometimes the fluke from the OP happens. However, It is possible to enter a new waypoint over it, you just have to do it "blind". After entering, the screen is normal again. I have had WPs carry over like that too a few times. In this case I was fresh into the server. [sIGPIC][/sIGPIC]
Recommended Posts