Mission 1 Issue.

[bart]

Just started this campaign, and I must say it's great. Loving the voice overs and the back ground story....very well done:thumbup:

 

I have just completed mission 1 successfully, however I did have an issue with it and it was more luck than anything else I got the 100% success.

 

Here's what happened.

 

 

I got to waypoint 7 and received the factory strike request. The co-ordinates given by the JTAC were LM1979759710 which I entered in the CDU but this location was no where near the correct target location. It took me diagonally over the flight plan back to near waypoint 3 to a location on the ground which wasn't a factory. When I requested the JATAC to pop the red smoke again I just happened to see the correct location to my left between waypoints 8 and 9. I marked this with a mark point and got the TGT on it and there was the factory.

 

So is there a current bug with the campaign entering of JATAC co ordinates or is this a known issue?

 

 

Any help on this would be appreciated.

 

 

Thanks for the great campaign. Looking forward to mission 2 :)

[Ranger79]

There is no bug with the factory coordinates, if you are looking through the TGP it is usually masked. Make sure you have the correct prefix.

 

Sent from my SAMSUNG-SM-N910A using Tapatalk

[bart]

Hi Ranger....thanks for your reply.

 

I tried the exact same coordinates when I was on the AO server last night and they worked fine. Took me to the exact location of the target in the campaign so they were good. I may try and repeat mission 1 again later and see what happens, but for now I'm going to continue with the campaign.

 

Just thought I would make a post just incase there happened to be an issue.

 

Great campaign though, very atmospheric. Good work :thumbup:

Edited February 26, 2017 by bart

[Ranger79]

Hi Ranger....thanks for your reply.

 

I tried the exact same coordinates when I was on the AO server last night and they worked fine. Took me to the exact location of the target in the campaign so they were good. I may try and repeat mission 1 again later and see what happens, but for now I'm going to continue with the campaign.

 

Just thought I would make a post just incase there happened to be an issue.

 

Great campaign though, very atmospheric. Good work :thumbup:

 

Thanks Bart, once 2.5 comes out I will be ensure all missions are operational and updating the supporting documentation to be more print and read friendly.