Kreye Posted February 7, 2018 Share Posted February 7, 2018 Hi guys I can't get my infantry to e.g. go back from waypoint 8 to 2 and have them run the pattern again. It works fine with tankers and awacs. Any ideas? Link to comment Share on other sites More sharing options...
feefifofum Posted February 7, 2018 Share Posted February 7, 2018 (edited) Under triggered actions -> commands you can find "go to waypoint" Create a series of trigger zones at the group's different waypoints, then create a series of triggers: SWITCHED CONDITION (Group at WP1, NO EVENT) PART OF GROUP IN ZONE (Group 1, WP 2) AI TASK PUSH (Group 1, 1. Go to waypoint 2...) etc. etc. Alternately you can use MiST or MOOSE to create patrols if you aren't opposed to writing .lua If you want an example of how to do this with built in Mission Editor stuff, check out my training range HERE which has a couple of convoys set up this way. Edited February 7, 2018 by feefifofum THE GEORGIAN WAR - OFFICIAL F-15C DLC Link to comment Share on other sites More sharing options...
grunf Posted February 7, 2018 Share Posted February 7, 2018 I don't think Go to waypoint works for ground units. https://forums.eagle.ru/showthread.php?t=192989 Link to comment Share on other sites More sharing options...
feefifofum Posted February 7, 2018 Share Posted February 7, 2018 Suuure does. See the attached .miz in the post I linked for examples. It's not something you can do without triggers like you can with aircraft, but it is very much possible via AI TASK PUSH. 1 THE GEORGIAN WAR - OFFICIAL F-15C DLC Link to comment Share on other sites More sharing options...
grunf Posted February 7, 2018 Share Posted February 7, 2018 Suuure does. See the attached .miz in the post I linked for examples. It's not something you can do without triggers like you can with aircraft, but it is very much possible via AI TASK PUSH. Good to know it works with triggers, thanks! Link to comment Share on other sites More sharing options...
Thorsfury Posted February 9, 2018 Share Posted February 9, 2018 I don't seem to be able to select an AI TASK from the drop down list: http://prntscr.com/ic89ax I have the waypoint tasks set up: http://prntscr.com/ic89qw Link to comment Share on other sites More sharing options...
Thorsfury Posted February 9, 2018 Share Posted February 9, 2018 Fixed, I was not adding the actions in the 'triggered actions'! Link to comment Share on other sites More sharing options...
tflash Posted February 11, 2018 Share Posted February 11, 2018 Another possibility is to set a flag and set this flag as a condition in the Task. [sIGPIC][/sIGPIC] Link to comment Share on other sites More sharing options...
Recommended Posts