JaBoG32_Prinzartus Posted June 25, 2018 Share Posted June 25, 2018 During pattern Training my Warthog Stcik just broke. The greyish inner metal shaft broke just at the point were it lead into the black metal-grip. :( Buttons and electronics should bei fine, but I need some replacement hardware. Has any one experienced the same? I am totally surprised that that this metal rod broke, before anything else. Any ideas fellas? :helpsmilie: Anyone got an unused stick to offer. Windows 10, I7 8700k@5,15GHz, 32GB Ram, GTX1080, HOTAS Warthog, Oculus Rift CV1, Obutto R3volution, Buttkicker [sIGPIC][/sIGPIC] ЯБоГ32_Принз Link to comment Share on other sites More sharing options...
Vladinsky Posted June 25, 2018 Share Posted June 25, 2018 You might be able to get a new part from thrustmaster, alternatively get one of these. https://www.shapeways.com/shops/debolestis?section=Tailpieces&s=0 The steel prints are a bit pricey but they're ridiculously strong. Link to comment Share on other sites More sharing options...
98abaile Posted June 27, 2018 Share Posted June 27, 2018 During pattern Training my Warthog Stcik just broke. The greyish inner metal shaft broke just at the point were it lead into the black metal-grip. :( Buttons and electronics should bei fine, but I need some replacement hardware. Has any one experienced the same? I am totally surprised that that this metal rod broke, before anything else. Yes, just recently infact (except I dropped it with and extension on). I contacted TM and they said that they don't offer the tail piece as a spare part and that I'd have to order a new grip. Luckily debolestis has modeled a pretty extensive set of replacement tail option on shapeways, so I ordered a new one in nylon (cost about £12) and it fits pretty well. Link to comment Share on other sites More sharing options...
raptorman0 Posted October 20, 2018 Share Posted October 20, 2018 Just happened to me. Sheared right through Link to comment Share on other sites More sharing options...
chief Posted October 21, 2018 Share Posted October 21, 2018 Like vladinsky said go to shapeways. I got the part you need.... Will the 15 degree angle one. Didn't get the metal one. But it works great. Just get a couple of them in case it breaks again. Link to comment Share on other sites More sharing options...
Recommended Posts