TPOD bug?

[SVK_Daniel]

As I wrote in wrong section I think there is a bug in TPOD specialy when I play FIRE BRIDGE mission.TPOD is not working a few minutes.TRACK is atached.

TPOD bug .trk

[Ramsay]

TPOD is not working a few minutes.TRACK is attached.

I didn't watch the track all the way through but what I saw, looked correct.

 

The TPOD IMU alignment takes approx 3 minutes, which occurred just after you fired the sidearms and turned out to sea.

 

"F−NOTRDY" was displayed as the TPOD FLIR sensor was still cooling down and the FLIR image degraded.

 

The cooling process takes 6-8 minutes, so the "F−NOTRDY" message should have cleared 3-5 minutes after the TPOD CCD started working.

 

Note: I'm not sure if "F−NOTRDY" should be displayed in the middle of the working CCD image, as it makes the CCD mode pretty much unusable until the FLIR sensor is ready ? Hopefully it's WIP, rather than how it works IRL.

Edited September 2, 2018 by Ramsay

[SVK_Daniel]

I didn't watch the track all the way through but what I saw, looked correct.

 

The TPOD IMU alignment takes approx 3 minutes, which occurred just after you fired the sidearms and turned out to sea.

 

"F−NOTRDY" was displayed as the TPOD FLIR sensor was still cooling down and the FLIR image degraded.

 

The cooling process takes 6-8 minutes, so the "F−NOTRDY" message should have cleared 3-5 minutes after the TPOD CCD started working.

 

Note: I'm not sure if "F−NOTRDY" should be displayed in the middle of the working CCD image, as it makes the CCD mode pretty much unusable until the FLIR sensor is ready ? Hopefully it's WIP, rather than how it works IRL.

 

I know what you mean,but first a few minutes has TPOD no reaction on OSB butons as I show in that track.Code 1111 is flashing etc.I tryed another missions even multyplayer and there is TPOD CCD even FLIR working imediatelly ,reacting on OSB butons,even I didnt need to wait for alignment of TPOD.Maybe it depends from mission, server setup etc. :thumbup:

[Zeus67]

I'll check the issue