JTAC in Persian Gulf

[sunski34]

Hi,

 

I put a JTAC in my mission (I've already done that in Caucasus but on old version of DCS, I need to retry now in Caucasus to be sure), but sometimes JTAC told me to abord !!!

 

But I think all is good :

 

-> Contact JTAC

-> Respond

-> Ready to copy

-> Read 9 line

-> Copy remarks

-> INBOUND than he said CONTINUE

-> In menu, LASER ON... But when I drop my bomb GBU12 (before LASING), he told me ABORD three times. Then I can't do anything.

 

If it works the first time, then JTAC said SHIFT.... But I can't LASE again. Strange.

 

 

What is the problem. I noticed there are more options in F9 menu... so, perhaps the process changed ?

 

I attached the mission, use the in air aircraft... In that case, JTAC is a drone but it's the same problem using a ground JTAC

Petroleum Crisis V1.miz

Edited October 8, 2018 by sunski34

[sunski34]

The problem is the same with Caucasus map.

 

But more precisions :

• The ennemy group to lase has few vehicules, all visible.
  
• The first time the process doesn't change (Contact.... IP INBOUND ... LASING). That's ok, target is destroyed
  
• Then JTAC said SHIFT and you can SHOT, SHIFT, TERMINATE. I chose SHOT
  
• Then IN
  
• Then IP INBOUND .... If you try this in a different position than the first time, JTAC said Stop stop stop... If you do that at the same position, no problem... JTAC said CONTINUE but you can't LASE again. The menu is IN again. If you drop the bomb no lasing...Bad shoot.
  

[sunski34]

I understood !

 

Nobody has respond but I understood that JTAC (with laser) process has changed.

 

When IP IN BOUND, you have to :

 

-> LASER ON

-> Select target point then SPOT

-> Then IN -> JTAC give you informations

-> Then drop GBU at good time

 

Then you can perform another attack , go to IP then IP IN BOUND .... same process.

 

There's several options but I don't test them yet (like TEN SECOND etc...)

 

I hope that help people.