dave76 Posted November 3, 2018 Share Posted November 3, 2018 guys i turn ecm commands(dispenser on, ecm xmit , aux rel enbl) on but cannot launch either chaff and flares ......any reason for that?:huh::huh::cry::cry: Link to comment Share on other sites More sharing options...
Mule Posted November 3, 2018 Share Posted November 3, 2018 (edited) You need to program that in on the EW page. Give me a minute and I will dig out a thread that explains how to do it. You also need to have Master Arm on. It's not complicated and there are some very good reasons why it's done this way. Edited November 3, 2018 by Mule Fighter Pilot Podcast. Link to comment Share on other sites More sharing options...
Mr_sukebe Posted November 3, 2018 Share Posted November 3, 2018 I’ve got to ask, did you turn on your master arm? System: 9700, 64GB DDR4, 2070S, NVME2, Rift S, Jetseat, Thrustmaster F18 grip, VPC T50 stick base and throttle, CH Throttle, MFG crosswinds, custom button box, Logitech G502 and Marble mouse. Server: i5 2500@3.9Ghz, 1080, 24GB DDR3, SSD. Link to comment Share on other sites More sharing options...
Mule Posted November 3, 2018 Share Posted November 3, 2018 This might help. Look at the video. https://forums.eagle.ru/showthread.php?t=210897 Fighter Pilot Podcast. Link to comment Share on other sites More sharing options...
CheeseCake Posted November 3, 2018 Share Posted November 3, 2018 (edited) if you have it in bypass the most upward position of the dispenser switch aft/forward will drop 2 of there respected CM's the middle position is programed witch you do with one of your DDIs on the EW page (programs 1-5 prog 5 is always selected as forward and you can have 1, 2, 3 or 4 set as aft) and bottom is off Redkite does a really good video on this like all his others ( ) explaining how the countermeasures work in the hornet Edited November 3, 2018 by CheeseCake Link to comment Share on other sites More sharing options...
Wizard_03 Posted November 3, 2018 Share Posted November 3, 2018 Make sure you actually have one of the programs selected. Go to EW page and push the OSB under the Mode label. You'll see the status change from standby to program 1,2,3 ect. It's default setting is standby so you'll have to do this every time you power up the dispenser. DCS F/A-18C :sorcerer: Link to comment Share on other sites More sharing options...
dave76 Posted November 4, 2018 Author Share Posted November 4, 2018 I’ve got to ask, did you turn on your master arm? yes i did :thumbup: Link to comment Share on other sites More sharing options...
Recommended Posts