Jump to content

Trim to neutral?


oho

Recommended Posts

I get a "check trim" message after cat-start and can't get rid of the message.

In the FCS I see stabilators moving +1 / -1 without me using the trim button.

Do you have a tip for easyly set trim to a neutral position again?

Link to comment
Share on other sites

“V” to set standard trim for runway, or the correct trim settings for actual weight if you’re about to take off from carrier.

 

In the FCS I see stabilators moving +1 / -1 without me using the trim button.

 

You should try to set some little deadzone value to the joystick axis.


Edited by pokeraccio
Link to comment
Share on other sites

T/O From Airfield Standard Take Off Trim is +12 (key "V" will setup / Reset For you)

 

T/O From Carrier needs more units and is Actual Aircraft Weight related:

44000Lbs and below +16 Units

45000 - 48000 +17

49000 and Above +19

 

I suggest to have a look at the F18 Flight Manual in your DCS main folder I got it in

C:\Program Files\Eagle Dynamics\DCS World OpenBeta\Mods\aircraft\FA-18C\Doc

 

DCS FA-18C Early Access Guide EN.pdf You'll find pretty much everything in this PDF

 

 

In the Chapter PROCEDURE from Pag.80 there are infos about Trim Settings

 

bye

Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...