Jump to content

Cold start


Pinefang

Recommended Posts

When cold starting the manual says to hold the {Y} key down while pressing the bit/FCS OSB. There is no FCS button on the bit page. Was this changed after the initial manual was written? The picture in the manual show the FCS OSB but I sure can't find that page.

Link to comment
Share on other sites

There should be an FCS option for a BIT test, located at the left side, top spot of the DDI options.


Edited by Harker
right to left

The vCVW-17 is looking for Hornet and Tomcat pilots and RIOs. Join the vCVW-17 Discord.

CVW-17_Profile_Background_VFA-34.png

F/A-18C, F-15E, AV-8B, F-16C, JF-17, A-10C/CII, M-2000C, F-14, AH-64D, BS2, UH-1H, P-51D, Sptifire, FC3
-
i9-13900K, 64GB @6400MHz RAM, 4090 Strix OC, Samsung 990 Pro

Link to comment
Share on other sites

FCS is on the Top LEFT of the BIT page (OSB 5 maybe?), you will need to press the top left once to get to the sub menu and then again whilst holding the BIT switch to run the BIT.

Corrent, top left of the (usually) right DDI. Thanks, brain! :music_whistling:

The vCVW-17 is looking for Hornet and Tomcat pilots and RIOs. Join the vCVW-17 Discord.

CVW-17_Profile_Background_VFA-34.png

F/A-18C, F-15E, AV-8B, F-16C, JF-17, A-10C/CII, M-2000C, F-14, AH-64D, BS2, UH-1H, P-51D, Sptifire, FC3
-
i9-13900K, 64GB @6400MHz RAM, 4090 Strix OC, Samsung 990 Pro

Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...