dokken1212 Posted April 2, 2020 Posted April 2, 2020 (edited) Hi folks, I wonder if anyone can help me please. When I go into DCS to configure my Warthog setup all the axis, thrust etc work. However none of the buttons or switches are being recognised. I checked in Windows and all buttons, axis, switches etc are being recognised. I tried unplugging and replugging in - no effect, tried resinstalling warthogdrivers - no effect. So i'm kinda out of ideas - went beyond my limited knowledge now !!. Any advice/help/tips would be HUGELY welcomed. Thanks so much and all the very best Edited April 2, 2020 by dokken1212 Computer Specs: AMD Ryzen 9 3900x Thermaltake 360 AIO Water Cooler 32GB Corsair Vengeance 3600Mhz RGB RAM GeForce RTX 2080 Super [ NVIDIA] 512GB Adata M2 NVME (boot drive) 1TB Adata M2 NVME 1TB WD Blue SSD Corsair RM850x Power Supply Phanteks Enthoo Evolve Case Samsung 43" 4K Smart TV (used as monitor) TRACK IR 5 + Wireless DelanClip Head Tracker Thrustmaster Warthog HOTAS :pilotfly::pilotfly::pilotfly::pilotfly::pilotfly::pilotfly::pilotfly:
VpR81 Posted April 2, 2020 Posted April 2, 2020 Try a installation repair, maybe this helps. If not, i'd try to map a few buttons and switches in Target and look if the input via the virtual controller is recognised in DCS. Phanteks EvolvX / Win 11 / i9 12900K / MSI Z690 Carbon / MSI Suprim RTX 3090 / 64GB G.Skill Trident Z DDR5-6000 / 1TB PCIe 4.0 NVMe SSD / 2TB PCIe 3.0 NVMe SSD / 2TB SATA SSD / 1TB SATA SSD / Alphacool Eisbaer Aurora Pro 360 / beQuiet StraightPower 1200W RSEAT S1 / VPC T50 CM2 + 300mm extension + Realsimulator F18 CGRH / VPC WarBRD + TM Warthog grip / WinWing F/A-18 Super Taurus + F-15EX / 4x TM Cougar MFD / Slaw Device RX Viper V3 / HP Reverb G2
Recommended Posts