Lynchsl62 Posted October 18, 2020 Share Posted October 18, 2020 I have the Brunner CLS-E FFB Joystick base for a year now and use it with Prepar3D especially for propeller and early jets, adds so much. I have imstalled the script as per the instructions for DCS, but when I run the software to connect it will not connect to DCS and acts a dumb base. My DCS installation is on the 2nd drive, the D: drive but I have copied the *.lua files over and still does not work - really want to use it for DCS propeller and 1st/2nd Generation Jets - anyone got it working and what am i doing wrong PC: 9980XE @ 64GB RAM /2080Ti, Samsung C49RG90 Joystick bases: VKB GFIII, FSSB R3L, Brunner CLS-E, Virpil Mongoos CM2 Joystick grips: Realsimulator (F-18CGRH, F-16SGRH-CE), VKB (MCG Pro, F-14, KG-12), Virpil Warbrd Throttles: Virpil CM2, Kantorrin, Other: TrackIR, TM MFDx2 (Cubesim Screenx2), Virpil Control Panel 1 Link to comment Share on other sites More sharing options...
Extranajero Posted October 19, 2020 Share Posted October 19, 2020 I'm not sure what the issue is, I ran the plugin installer and it just connected. I don't use vJoy though, no idea how you use that to get the built in DCS FFB effects, I just programmed force curves based on what I know about the aircraft - they are then modified in the Brunner software according to the IAS output it gets from the DCS plugin. Works very, very well but not plug and play. --------------------------------------------------------- PC specs:- Intel 386DX, 2mb memory, onboard graphics, 14" 640x480 monitor Modules owned:- Bachem Natter, Cessna 150, Project Pluto, Sopwith Snipe Link to comment Share on other sites More sharing options...
Recommended Posts