DD_Fenrir Posted April 30, 2021 Share Posted April 30, 2021 Consistently those of us attempting to fly realistic missions at prototypical lengths and attempting to use prototypical recommended* engine settings (low RPM, "high" boost) in order to (a) eek out some semblance of the range that these aircraft were capable of flying and (b) fly in a prototypical manner, we are experiencing coolant temperatures of sub-60° for long periods of flight and this seems to consistently be resulting in engine failure due to overcooling. Even long periods at max continuous settings, 2650 RPM @ +7 lb/sqin boost, temperatures seem suspiciously low. If there was some documentary warning or evidence that this was an issue for the Spitfire IX in particular or Merlins in general, then fair enough, but we cannot find a single warning in any period documentation, including the Pilots Notes, that covers this fallibility. Given the following attached documentation shows that these settings were RECOMMENDED for operations, it would seem a critical omission not to warn pilots of the risks of operating at them, if overcooling was actually an issue. Hence we believe this behaviour in DCS is inaccurate. We've been told there was supposed to be a revision to the thermodynamic/coolant models some time ago. We hope that this is imminent and that it sorts this issue. 7 Link to comment Share on other sites More sharing options...
Moriarty Posted May 1, 2021 Share Posted May 1, 2021 I’ve observed this behavior as well on Normandy and Channel maps the last few flights, in Summer months and Summer temps at all altitudes up to 25K’. The temps drop, oil pressure rises, and the choice is usually to fly at max continuous or higher. Link to comment Share on other sites More sharing options...
Nealius Posted May 2, 2021 Share Posted May 2, 2021 I'm fairly certain this has been a long-standing issue. I remember trying The Big Show campaign back on 2.5.6 and my engine would always die from overcooling on my descent while RTB. I had to run max continuous but doing so guzzled gas and I overshot all my other assets in the package because they were going so slow. Link to comment Share on other sites More sharing options...
grafspee Posted May 2, 2021 Share Posted May 2, 2021 (edited) Spitfire's cooling modeling isn't complete. It is copy pasted from P-51, but spitfire oil and coolant system consist thermostatic valves to cut off oil and coolant radiators when temps drops below 80C. DCS is missing that feature. In P-51 temps are regulated by controling air flow through radiators, in case of spitfire air flow is constant, only amount of oil/coolant flowing through radiators is controlled via thermostatic valves. Thermostatic valves aren't modeled so full flow through radiators is allowed. This makes very difficulty to warm up engine in winter time, or sometimes make it impossible to warm up engine if temp is very low, another issue is low power cruise at high alt where. I've seen oil temp going to 0 C. Edited May 2, 2021 by grafspee 4 System specs: I7 14700KF, Gigabyte Z690 Aorus Elite, 64GB DDR4 3600MHz, Gigabyte RTX 4090,Win 11, 48" OLED LG TV + 42" LG LED monitor Link to comment Share on other sites More sharing options...
-0303- Posted May 2, 2021 Share Posted May 2, 2021 (edited) That's a major modeling shortcoming. Can't fly at alt or cold weather. Edited May 3, 2021 by -0303- 1 Intel Core i7 3630QM @ 2.40GHz (Max Turbo Frequency 3.40 GHz) | 16.0GB Dual-Channel DDR3 @ 798MHz | 2047MB NVIDIA GeForce GT 635M | 447GB KINGSTON SA400S37480G (SATA-2 (SSD)) Link to comment Share on other sites More sharing options...
Moriarty Posted May 3, 2021 Share Posted May 3, 2021 To get traction on this issue we might have to prove that the RR Merlin engine isn’t supposed to freeze in operations under normal conditions. But how? Hard to find such archival evidence from so long ago. 2 Link to comment Share on other sites More sharing options...
grafspee Posted May 3, 2021 Share Posted May 3, 2021 (edited) 5 hours ago, Moriarty said: To get traction on this issue we might have to prove that the RR Merlin engine isn’t supposed to freeze in operations under normal conditions. But how? Hard to find such archival evidence from so long ago. You don't need to prove anything, straight from DCS spitmanual. Edited May 3, 2021 by grafspee 1 System specs: I7 14700KF, Gigabyte Z690 Aorus Elite, 64GB DDR4 3600MHz, Gigabyte RTX 4090,Win 11, 48" OLED LG TV + 42" LG LED monitor Link to comment Share on other sites More sharing options...
ED Team BIGNEWY Posted May 6, 2021 ED Team Share Posted May 6, 2021 Work on cooling is on the to do list, I will pass on your feedback to the team thanks 2 Forum rules - DCS Crashing? Try this first - Cleanup and Repair - Discord BIGNEWY#8703 - Youtube - Patch Status Windows 11, NVIDIA MSI RTX 3090, Intel® i9-10900K 3.70GHz, 5.30GHz Turbo, Corsair Hydro Series H150i Pro, 64GB DDR @3200, ASUS ROG Strix Z490-F Gaming, HP Reverb G2 Link to comment Share on other sites More sharing options...
-0303- Posted May 8, 2021 Share Posted May 8, 2021 On 5/3/2021 at 7:39 AM, grafspee said: You don't need to prove anything, straight from DCS spitmanual. Referring to figure. Essentially (4) is the thermostatic valve that directs coolant straight to pump (7) bypassing the radiators (6) as long as coolant temp is below 80'C. If that isn't modeled, that's a shortcoming. "Tunnel dampers" must refer top the flap opening if coolant temp exceeds 115'C or if radiator switch is flipped to ON. "...that regulate the coolant temperature and oil." Bit of a word salad. It's a combined coolant / oil radiator? Original manual probably clearer. Intel Core i7 3630QM @ 2.40GHz (Max Turbo Frequency 3.40 GHz) | 16.0GB Dual-Channel DDR3 @ 798MHz | 2047MB NVIDIA GeForce GT 635M | 447GB KINGSTON SA400S37480G (SATA-2 (SSD)) Link to comment Share on other sites More sharing options...
grafspee Posted May 8, 2021 Share Posted May 8, 2021 (edited) And I could not find anything about oil thermostat, so my error, oil system does not have any temp regulation. But coolant system does have thermostat which diverts coolant in to headed instead of radiator, when droping power. Edited May 8, 2021 by grafspee System specs: I7 14700KF, Gigabyte Z690 Aorus Elite, 64GB DDR4 3600MHz, Gigabyte RTX 4090,Win 11, 48" OLED LG TV + 42" LG LED monitor Link to comment Share on other sites More sharing options...
Wiggy Posted May 10, 2021 Share Posted May 10, 2021 Oil system has a viscosity valve, obviously oil viscosity relating directly to its temperature. Exactly the same idea, when viscosity is too high it’ll remain closed and oil will bypass the radiator. This clearly isn’t modelled in DCS currently either as the oil temp is remaining way too cool. There’s a pressure relief valve in the oil system which is pretty self-explanatory. Spring pressure is calibrated to open at 80psi. Again, this certainly isn’t modelled in DCS. At the moment I’m hitting 130+psi at max. cruise at altitude. 90-100 in level flight even at low altitude. It should be regulated between ~45-80psi. It’s all a bit of a mess at the moment unfortunately. For those of us running longer missions and more realistic profiles it is having a more noticeable impact, running the engine so far out of whack for longer periods is causing engine failure/total seizure. Mustang is also affected it seems. My thoughts are this new cooling model needs upping on the priority list. 2 Link to comment Share on other sites More sharing options...
grafspee Posted June 29, 2021 Share Posted June 29, 2021 Unless you go oil dilution so you can cheat on your viscosity valve System specs: I7 14700KF, Gigabyte Z690 Aorus Elite, 64GB DDR4 3600MHz, Gigabyte RTX 4090,Win 11, 48" OLED LG TV + 42" LG LED monitor Link to comment Share on other sites More sharing options...
Reflected Posted January 17, 2022 Share Posted January 17, 2022 Any updates on this please? This completely prevents us from playing realistic Spitfire missions, cruising at high altitudes, especially in cold weather. 7 2 Facebook Instagram YouTube Discord Link to comment Share on other sites More sharing options...
grafspee Posted January 17, 2022 Share Posted January 17, 2022 +1 4 System specs: I7 14700KF, Gigabyte Z690 Aorus Elite, 64GB DDR4 3600MHz, Gigabyte RTX 4090,Win 11, 48" OLED LG TV + 42" LG LED monitor Link to comment Share on other sites More sharing options...
DD_Fenrir Posted January 17, 2022 Author Share Posted January 17, 2022 +1 4 Link to comment Share on other sites More sharing options...
Screamadelica Posted January 18, 2022 Share Posted January 18, 2022 I'll add my vote for this. +1 This is an important issue, like the laser accurate flak. Things like this prevent you from playing these excellent campaigns as they should be. I hope there is a degree of priority given to sorting out some of these basic DCS WW2 issues. 4 Link to comment Share on other sites More sharing options...
grafspee Posted January 18, 2022 Share Posted January 18, 2022 Cooling bug is with spitfire since release so, i would say that this is high on priority list, but who knows. 1 System specs: I7 14700KF, Gigabyte Z690 Aorus Elite, 64GB DDR4 3600MHz, Gigabyte RTX 4090,Win 11, 48" OLED LG TV + 42" LG LED monitor Link to comment Share on other sites More sharing options...
razo+r Posted January 18, 2022 Share Posted January 18, 2022 Apparently it has a great enough priority to be disregarded for ever. 2 Link to comment Share on other sites More sharing options...
Screamadelica Posted January 19, 2022 Share Posted January 19, 2022 1 Link to comment Share on other sites More sharing options...
wowbagger Posted January 20, 2022 Share Posted January 20, 2022 +1 CPU:5600X | GPU:RTX2080 | RAM:32GB | Disk:860EVOm.2 Link to comment Share on other sites More sharing options...
Nealius Posted February 6, 2022 Share Posted February 6, 2022 +1. Big Show campaign gets dicy on fuel burn because we can't fly at proper cruise settings. 1 Link to comment Share on other sites More sharing options...
DD_Fenrir Posted February 6, 2022 Author Share Posted February 6, 2022 Ultimately this should be a feature implemented independently of a review of the thermodynamic modelling - the fact is the DCS Spitfires Merlin 66 is missing a system that prevents the temperature ever from dropping below 80 degrees once the engine is running, a system that has been proved unequivocally to be a feature of the real aircraft. 4 Link to comment Share on other sites More sharing options...
Wiggy Posted February 6, 2022 Share Posted February 6, 2022 +1 it’s been a while since we heard anything on this. Any news @NineLine @BIGNEWY ? Link to comment Share on other sites More sharing options...
ED Team BIGNEWY Posted February 6, 2022 ED Team Share Posted February 6, 2022 We are waiting for devs to finish cooling work on the Mossie and then that will help with the spits cooling work, I can give no ETA currently. Thanks for continuing to be patient. 3 1 Forum rules - DCS Crashing? Try this first - Cleanup and Repair - Discord BIGNEWY#8703 - Youtube - Patch Status Windows 11, NVIDIA MSI RTX 3090, Intel® i9-10900K 3.70GHz, 5.30GHz Turbo, Corsair Hydro Series H150i Pro, 64GB DDR @3200, ASUS ROG Strix Z490-F Gaming, HP Reverb G2 Link to comment Share on other sites More sharing options...
Wiggy Posted February 6, 2022 Share Posted February 6, 2022 Thanks for the update 1 Link to comment Share on other sites More sharing options...
Recommended Posts