Thallios Posted May 4, 2021 Share Posted May 4, 2021 After pressing the WPDSB button on the HSI or SA Page (DDI and AMPCD) the target point is locked (can be seen on HMD) but the Lightning POD ist not slewing to the target point and remains in snowplow mode. Even after undesignate and redesignate via WPSDG problem still remains. Power down and restart TGP dosn't work either. Weapons loadout was 2x IR Maverick and 4x GBU-12 Problem was observed after firing the Mavericks and dropping all GBU-12s. This problem happes from time to time and is not always observable direct from the start. I personally observed it after dropping all ordonance (mostly GBU-12) Link to comment Share on other sites More sharing options...
Tholozor Posted May 5, 2021 Share Posted May 5, 2021 (edited) Try cycling through the track modes (ATRK -> PTRK -> INR). I've noticed sometimes if I designate a TGT position with another sensor (e.g. AG radar) the pod doesn't slave immediately until I cycle the track mode. I'll try and get a track file up later when I'm not at work. Edited May 5, 2021 by Tholozor REAPER 51 | Tholozor VFA-136 (c.2007): https://www.digitalcombatsimulator.com/en/files/3305981/ Arleigh Burke Destroyer Pack (2020): https://www.digitalcombatsimulator.com/en/files/3313752/ Link to comment Share on other sites More sharing options...
Ahmed Posted May 5, 2021 Share Posted May 5, 2021 This is an old bug that happens the first time you slave the pod. Undesignating and designating again (after cycling waypoints too??) usually fixes it. I don't know exactly how to reproduce it but it has been there for a few months. Link to comment Share on other sites More sharing options...
Thallios Posted May 7, 2021 Author Share Posted May 7, 2021 Tried that in the observed situation, no effect Link to comment Share on other sites More sharing options...
Recommended Posts