Kiseki_Yu Posted September 24, 2021 Share Posted September 24, 2021 After the update on August 18, I found that in many cases, I cannot switch BST to VACQ directly in ACM modes. Namely, I need to go to WACQ firstly, and then from WACQ to VACQ (i.e., BST ---> WACQ ---> VACQ). Before the update, I can switch BST to VACQ directly (i.e., BST --->VACQ). Does somebody have the same issue? Thank you very much. Link to comment Share on other sites More sharing options...
Solution Hulkbust44 Posted September 24, 2021 Solution Share Posted September 24, 2021 This is correct behavior. With the HMD on SCS aft in the ACM condition commands UP LOOK. To use VACQ you must first enter WACQ.Mobius708 Link to comment Share on other sites More sharing options...
Kiseki_Yu Posted September 24, 2021 Author Share Posted September 24, 2021 6分钟前,Hulkbust44说: This is correct behavior. With the HMD on SCS aft in the ACM condition commands UP LOOK. To use VACQ you must first enter WACQ. Mobius708 Thank you so much! So the previous version is wrong! Link to comment Share on other sites More sharing options...
Tholozor Posted September 24, 2021 Share Posted September 24, 2021 21 minutes ago, Kiseki_Yu said: Thank you so much! So the previous version is wrong! Not necessarily. VACQ is still accessed with SCS Aft after entering ACM mode when the HMD knob is OFF. REAPER 51 | Tholozor VFA-136 (c.2007): https://www.digitalcombatsimulator.com/en/files/3305981/ Arleigh Burke Destroyer Pack (2020): https://www.digitalcombatsimulator.com/en/files/3313752/ Link to comment Share on other sites More sharing options...
Kiseki_Yu Posted September 25, 2021 Author Share Posted September 25, 2021 20小时前,Tholozor说: Not necessarily. VACQ is still accessed with SCS Aft after entering ACM mode when the HMD knob is OFF. Thank you for your explanation! Link to comment Share on other sites More sharing options...
Recommended Posts