OrangeSpy Posted November 6, 2021 Share Posted November 6, 2021 When I'm NOT using TARGET with the Thrustmaster Warthog HOTAS I have no issues using the flaps switch to control the state of the flaps in the Harrier. I just use the stateful configuration options for the throttle. If however I use TARGET software I cannot use the stateful joystick binds on the throttle switch (Cruise else AUTO and STOL else AUTO) as the are only usable on a joystick, not keyboard. Perhaps there's something simple I'm missing. Has anyone worked through this that can help? Thanks Link to comment Share on other sites More sharing options...
Britchot Posted November 19, 2021 Share Posted November 19, 2021 (edited) Are you using the GUI or the Script Editor? In the Editor, I use MapKeyR for my switch from up to middle or down to middle. When I get home today, I'll post the code. Edited November 19, 2021 by Britchot [sIGPIC][/sIGPIC] CPU - Intel 8088 @ 4.77 MHz; Memory - 128KB; 360KB double-sided 5 1/4" full-height floppy disk drive; 10MB Seagate ST-412 hard drive JG-1 MiG-21bis Checklist Link to comment Share on other sites More sharing options...
Britchot Posted November 19, 2021 Share Posted November 19, 2021 (edited) Fixed mine to be 3-positions. This is the scripting I use for the flaps: MapKey(&Throttle, FLAPU, FlapsCruise); MapKeyR(&Throttle, FLAPU, FlapsAuto); MapKeyR(&Throttle, FLAPD, FlapsAuto); MapKey(&Throttle, FLAPD, FlapsSTOL); These are my definitions: define FlapsCruise PULSE+R_SHIFT+'f' define FlapsAuto PULSE+R_CTL+'f' define FlapsSTOL PULSE+R_ALT+'f' Edited November 19, 2021 by Britchot [sIGPIC][/sIGPIC] CPU - Intel 8088 @ 4.77 MHz; Memory - 128KB; 360KB double-sided 5 1/4" full-height floppy disk drive; 10MB Seagate ST-412 hard drive JG-1 MiG-21bis Checklist Link to comment Share on other sites More sharing options...
doclucio Posted December 25, 2021 Share Posted December 25, 2021 excuse me, i am having difficulties mapping the flaps switch to hotas, it recognizes the up and down position only, any idea?!? Link to comment Share on other sites More sharing options...
Parasiticus Posted December 25, 2021 Share Posted December 25, 2021 55 minutes ago, doclucio said: excuse me, i am having difficulties mapping the flaps switch to hotas, it recognizes the up and down position only, any idea?!? Command: Flaps CRUISE else AUTO Command: Flaps STOL else AUTO 1 Link to comment Share on other sites More sharing options...
doclucio Posted December 26, 2021 Share Posted December 26, 2021 ok thks, clear thank you, dummy question sorry Link to comment Share on other sites More sharing options...
Recommended Posts