=36=Witcher Posted November 13, 2021 Share Posted November 13, 2021 During a PI bombing, after PI designation, VAL and REC buttons correctly lights up on the PCN. However, even though the PI procedure continues without any issue, pressing VAL does not update the INS, with the aforementioned buttons that stays lit. Only pressing REC make them turn off, but of course the INS is not updated. Track attached. CCPL_PI_Cannot_VAL.trk Link to comment Share on other sites More sharing options...
El Chapo Posted November 13, 2021 Share Posted November 13, 2021 (edited) Hi. On some M2000 there is a "parallel navigation" thing. If you are in a weapon mode the INS update is only taken into account during the attack and it's lost after. I'm not 100% sure it's what you are describing, but it could be. Best method is to do an "out of mode" INS update 5 minutes before the initial, and then an "in mode" INS update on the initial point. The advantage is that your waypoint cue in your HUD will be close to the actual point, thus making the visual acquisition easier and more precise, this making the attack itself more precise... Edited November 13, 2021 by Габихан 1 Link to comment Share on other sites More sharing options...
=36=Witcher Posted November 15, 2021 Author Share Posted November 15, 2021 I'm pretty sure it should work as I described, at least that's what I understood explaining the issue to @myHelljumper Link to comment Share on other sites More sharing options...
myHelljumper Posted November 21, 2021 Share Posted November 21, 2021 Hi, The PI fix can only be accepted after the bombing run is done of when the SNA is returned to AG pre-selected or memorized. So the CCPL PI behavior is correct. Helljumper - M2000C Guru Helljumper's Youtube https://www.youtube.com/channel/UCK3rTjezLUxPbWHvJJ3W2fA Link to comment Share on other sites More sharing options...
Recommended Posts