Draken35 Posted November 15, 2021 Share Posted November 15, 2021 I was reading in the new manual (ch1-ch15) that the Tacan Offset can be used for LHA approaches but it doesn't says how and I can't think of a way. Does anybody knows? (Yes, I know how to use vanilla Tacan , without offset, to get in the boat) Link to comment Share on other sites More sharing options...
JackHammer89 Posted November 15, 2021 Share Posted November 15, 2021 With Tacan boxed you can set up an offset by clicking TO/S on the right hand side of the MPCD EHSD. Then on the UFC enter a BRG - bearing in degrees Then a range in nautical Miles. You will now have a TACAN offset set up, it should a appear like a tacan beacon symbol on the EHSD with a few bits missing at the "points". (sorry if you already knew that bit, just trying to be helpful) If you were doing a CASE 2/3 you could set up your radial relative to the ship using the TACAN offset. You could use it for marking the initial for an overhead break. For marking 7DME or whatever after take off. A radial to fly away from the boat in CASE 2/3 launches. Link to comment Share on other sites More sharing options...
Draken35 Posted November 15, 2021 Author Share Posted November 15, 2021 Ah! I was thinking on terms on CASE 1's approaches ...I don't have much experiences with case 2 or 3 but I'll look into it. Thanks! 20 minutes ago, JackHammer89 said: you already knew that bit, just trying to be helpful) No worries. I know it but others might not. Link to comment Share on other sites More sharing options...
Recommended Posts