investigating Cannot select target in HAD after seting markpoint

[Topper81]

Steps to reproduce:

- Select a target in the HAD

- Activate markoint mode (TGP mode)

- Set TGP SOI

- Set a markpoint with TGP

- Fire Harm

- Set HAD SOI

- Try to select the target again when HAD is SOI (Not working)

Expected:

- It's possible to select a target because HAD is SOI and not TGP

Observed:

- It's not possible to select a target with the HAD (TMS Forward is stil "reserved" to create markpoints with TGP? But TGP is not SOI...)

HAD_Markoint.trk

Edited December 26, 2021 by Topper81

[jojojung]

Same for me. You have to leave Mark DED page via return. Then you can select new targets. Very complicated in a multi thread scenario. 

Hope this will be fixed in any way. 

[Carbon715]

I have found that exiting out of the mark point screen after you are done marking remedies a lot of issues

[Mud]

I think this is because when you're on the Mark point page, TMS up serves a different function (to drop a mark point).

However I don't know how this works in the real Viper with the HAD being SOI at that moment.

[BIGNEWY]

I will check with the team but I think you need to return from the mark point mode.