herr_LaSk Posted December 13, 2008 Share Posted December 13, 2008 Hi Guys, sorry for asking such a n00b question:music_whistling: I'm using a Saitek x52 Pro HOTAS, and everything worked fine except for one thing, the collective is assigned to the slider axis on the throttle quadrant instead of the actual throttle axis:huh:. Now, I went to the control options menu, however I cant figure out how to switch the axis assignments. In Lock On there was a swich at the top of the menu where you could switch between key assignments and axis assignments, but here I cant seem to find any way to manipulate the different axis on my HOTAS. In the manual it simply says that when you have assigned an input axis to an action, you can then press axis tune to adjust how the axis responds, but how do I acctually assign the axis to an action? Am I simply missing something obvious?:helpsmilie: Link to comment Share on other sites More sharing options...
Cougar Posted December 13, 2008 Share Posted December 13, 2008 Look in the drop down menu at the top, you should see an entry with Axis command in red. Link to comment Share on other sites More sharing options...
herr_LaSk Posted December 13, 2008 Author Share Posted December 13, 2008 :doh: haha, sorry:music_whistling: see it now. I guess i overlooked it because of the nice, red, obvious letters:D Anyway thanks! Link to comment Share on other sites More sharing options...
rviii Posted December 13, 2008 Share Posted December 13, 2008 We all miss it to start with, this sim is on another level, the Axis is as mentioned above. Assign & deassign in the highlighted category. Fine tune & invert too, See ya in the air ;) www.legionofsparta.com Link to comment Share on other sites More sharing options...
Cougar Posted December 13, 2008 Share Posted December 13, 2008 :doh: haha, sorry:music_whistling: see it now. I guess i overlooked it because of the nice, red, obvious letters:D Anyway thanks! You're welcome! Link to comment Share on other sites More sharing options...
kizza42 Posted December 14, 2008 Share Posted December 14, 2008 Just a note, When I first installed BS. The Axis option wasn't in the drop down list, That had me puzzled for a while. I had to delete the controller config files and when I next launched it re-parsed and the option was there. Link to comment Share on other sites More sharing options...
MrReynolds Posted December 14, 2008 Share Posted December 14, 2008 I too, for the life of me couldn't find the axis commands in the drop down menu. A search on these forums pointed me in the right direction. I DIDN'T alter any files (i'm sure of it) but I just can't understand how I could have missed the red writing!!! :music_whistling: Link to comment Share on other sites More sharing options...
Recommended Posts