TADs Video on MPD / How to reset?

[Fakum]

Before I take off (As Pilot) I always set the Left MPD to TADs video (As shown here)

so I can see what the CPG is looking at. The annoyance is that whenever I get an RPM notice (or something like that) I get the Engine overlay (which is fine). If i want to get back to that same TADs video, I have to hey 3 buttons again. "VID" then "TADS"(R1) then "TADS" (T6). Is there a faster way to get this TADS back up every time so you dont have to mash 3 buttons every time? Yes, I know, dont over torque,,, besides that though, thanks.

[Raptor9]

Technically, the VID page should remain in the last state it was left, unless NO VIDEO was selected in which case the default underlay would display when returning to the VID page. The current behavior is inaccurate, and will hopefully be updated sometime in the future.

So in your case, when you press the VID button on the MPD, it should return you to the full screen TADS video like in your first image, but currently the behavior isn't reflecting that.

[sobe]

Use voice attack and do 3 commands or use RSMapper.

[Fakum]

Ok, thanks for that info.

Sorry Sobe, I responded same time you did. Good advice, didint even think to do Voice Atk