oscar19681 Posted May 2, 2022 Share Posted May 2, 2022 Cant find anything on it in the manual. So how do you use the recently implemented autopilot modes? [sIGPIC][/sIGPIC] Link to comment Share on other sites More sharing options...
Floyd1212 Posted May 2, 2022 Share Posted May 2, 2022 Try looking for "ATT Hold" and "ALT Hold". Note: ALT Hold is not implemented yet, and ATT Hold is partially implemented. Link to comment Share on other sites More sharing options...
Floyd1212 Posted May 2, 2022 Share Posted May 2, 2022 Hmm. Turns out that was not as helpful as I thought it would be... Link to comment Share on other sites More sharing options...
Floyd1212 Posted May 2, 2022 Share Posted May 2, 2022 The controls are discussed on pg 63 of the manual, and this thread has some useful information: 1 Link to comment Share on other sites More sharing options...
FalcoGer Posted June 17, 2022 Share Posted June 17, 2022 Press for trim release up to trim the aircraft. Hold up for a few moments to allow the SCAS to reset. Press force trim to the right to enter altitude hold. When within radar altitude limits (~1400ft) it will be a radar altitude hold. It is not a terrain following mode since only the radar altimeter data is used. Press force trim to the left to enter attitude or velocity hold mode. If below 5 knots, you will enter a position hold mode. From 5 to 40 knots you will enter a mode where the helicopter tries to maintain it's current heading and velocity. For example if you fly sideways to the right at 30 knots the helicopter will try to maintain the nose position and the 30 knot sideways movement. above 40 knots the helicopter will try to maintain it's speed. Link to comment Share on other sites More sharing options...
Recommended Posts