Settings To Start

[Johnpilot]

There are so many settings to try tweaking, it is a bit overwhelming.  Appreciate ideas on a good preset to start.  Here are my specs:

i7 11700, 2.5 GHz 8 cores

16 G RAM at 3200 MHz

RTX 3060 12Gb

1 TB SSD NVMe M.2

ASUS 34" curved monitor

Thanks.

[LucShep]

Try something like this as a starting point:




I use resolution at 3840x2160 (4K is native res. of my screen) - set yours to the native resolution of your screen.
I use VSYNC "ON" because that's what works best for me, but you may wish to try it at "OFF", especially if using Freesync or GSync.
I use GAMMA at "2", but adjust that as you see fit (increase for brighter image, decrease for darker image).

If performance is good, perhaps increase a few settings here and there, starting by increasing Anisotropic Filter (to 16x), MSAA (to 4x), and VISIB.RANGE, other settings following.

Experimentation on settings is up to you.
Some small advice on settings (YMMV) can be found in the 2nd post of the following thread: 

As side note, and FWIW, I use Simplex Shaders, which provides slightly better performance, with no downsides whatsoever (IMO).

Edited May 6, 2022 by LucShep

[Johnpilot]

Thank you.  I will start to get setup later on.

[Pindol]

Hello, I would like to ask for a hint of DCS graphic settings.
  i7 8086k O / C 5.2ghz
RAM memory 64 GB
Msi Rtx 3080 Ti Suprim X graphics card
Crucial MX100 SSD 512GB hard drive
  Tv TCL 43P725 43 "LED 4K

thank you.