Freakmeister51 发布于2022年6月21日 发布于2022年6月21日 Can this topic be revisited please. I have tried just about every conceivable combination of rudder and aileron trim i can, i have tried the mod that was published a while ago on this forum. The aircraft still continues to fly with a roll to the left. Surely, the trim tab facility on the real aircraft rectifies this issue. Feel free to correct me if i am wrong but i'm sure, in real life a pilot would tire pretty quickly if he had to continually apply stick pressure to keep wings level.
Toriy 发布于2022年6月21日 发布于2022年6月21日 1 hour ago, Freakmeister51 said: ... the trim tab facility on the real aircraft rectifies this issue. The factory settings of the compensating tabs on the ailerons balance the aircraft at a speed of 250 km/h, as for rudder tab I am not sure.
Freakmeister51 发布于2022年6月21日 楼主 发布于2022年6月21日 49 minutes ago, Toriy said: The factory settings of the compensating tabs on the ailerons balance the aircraft at a speed of 250 km/h, as for rudder tab I am not sure. Thanks for that Toriy. I generally don't fly the Yak at that speed, normally close to 200 km/h. I have found that the aircraft generally flies to the right when wings are level, if i try to trim the ball out the aircraft rolls to the left. I'll try to add a track file to illustrate this tomorrow.
Alexey251 发布于2023年3月17日 发布于2023年3月17日 (已编辑) Well except of this issue I`ve noted unrealistic ability to fly on "blade" , ( ie tip of wing looks to ground at 90 * ), moreover with the Instructor in 2d cockpit! I`ve got quite a lot practice as aerobatic pilot ( Yak 52 engine 420 hp)but never saw such tricks with 2 persons onboard.... Also should tell I could not find how to "show stick" in cockpit? Another strange thing- lock of brakes! This button shows unpredictable results when you need to warm up engine- sometime holding aircraft on place, sometime you start suddenly speeding up! Also looks strange so called "flat spin (not inverted). Aircraft goes out from this one by itself when you keep stick and rudder in neutral position. Its absolutely out of reality! 本帖最后于2023年3月18日，由Alexey251编辑
gulredrel 发布于2023年3月18日 发布于2023年3月18日 Regarding the brake lock, it's in fact small device holding the brake lever. If you push and release the brake, the brake lock releases. I guess, this happens also when you have brake to axis and the axis is a bit jittering. You may want to check this.
已推荐帖子