Boresight modes not working (Both)

[dorianR666]

this is still not fixed? huh

[dorianR666]

boresight modes still broken in yesterdays OB.

also id like to add that even when they happen to work and lock something, they break again when the target leaves gimbal limits. and you have to do the whole dance with the switch again.

[IvanK]

Boresight works just fine for me both ST and MT.

Dont understand your comment ref Gimbal limits ... its normal for break lock to occur if you let the target drift outside the radar gimbal limits.

BZ mode is still in development.

本帖最后于2023年3月11日，由IvanK编辑

[kontiuka]

57 minutes ago, dorianR666 said:

boresight modes still broken in yesterdays OB.

also id like to add that even when they happen to work and lock something, they break again when the target leaves gimbal limits. and you have to do the whole dance with the switch again.

 

19 minutes ago, IvanK said:

Boresight works just fine for me both ST and MT.

Dont understand your comment ref Gimbal limits ... its normal for break lock to occur if you let the target drift outside the radar gimbal limits.

BZ mode is still in development.

 

Right.  BZ mode isn't implemented yet.

For TL, it matters the order in which you select it.  If you go from regular scan to BZ then to TL, it won't work.  But if you go from regular scan to TL, it works.

[dorianR666]

5 hours ago, IvanK said:

... its normal for break lock to occur if you let the target drift outside the radar gimbal limits.

the point is that the radar wont be scanning anything afterwards, it gets blind. not even the clutter effect. you have to return to the "RWS", then TL, then BZ to make BZ work again.

 

4 hours ago, kontiuka said:

BZ mode isn't implemented yet.

i see.