unable to reproduce Unable to designate Offset from SA page + small addition

[Harker]

2.7.16.27869 Open Beta

1. Set up an Offset to a Waypoint.
2. Switch to the SA page.
3. Press WPDSG to designate the WP. -> A designation is created on the WP location and O/S shows up.
4. Press O/S in order to designate the Offset location. -> Nothing happens, the designation remains on top of the WP location and the O/S option remains visible.
5. Switch back to HSI and observe that O/S works correctly.

 

Small addition to https://forum.dcs.world/topic/292704-offset-point-still-wrong-since-available-wrong-mark-sa-page-possition/ , didn't want to make a separate report. I have observed that the Offset symbol on the SA page will simply move with the aircraft (you move +5 nm East, the Offset symbol will also move +5 nm East on the SA page. It resets to the correct position when you switch to the HSI, only to start drifting again once you switch to the SA.)

 

FA-18C_Offset doesn't work with SA page.trk

Edited July 28, 2022 by Harker

[BIGNEWY]

Hi, the team is unable to reproduce, please retry and let me know how you get on, this may already be fixed. 

thank you

[rob10]

@BIGNEWY I just ran into the 2nd part of Harker's report above.  Had the issue on Syria map and reproduced with short track on Nevada map.  At end of the track you'll see that the O/S point stays where it should on the HSI, but on the SA page it keeps itself offset from your plane.

 

OS moving 2.trk

Edited October 18, 2022 by rob10
Replaced original track with track after removing mods.