Caldera Posted September 4, 2022 Share Posted September 4, 2022 (edited) Hey all, A new controller that has a three position switch. I can't figure out how to make the flaps work the way I would like. This is the three position switch in cockpit. This is the control options. Any way to directly place the switch in UP, MVR or DN? Thanks in advance, Caldera Edited September 4, 2022 by Caldera Website hosed me again... Link to comment Share on other sites More sharing options...
Chain_1 Posted September 4, 2022 Share Posted September 4, 2022 Check out the community keybinds mod. The settings you're looking for may be in there. Link to comment Share on other sites More sharing options...
Yurgon Posted September 5, 2022 Share Posted September 5, 2022 2 hours ago, Caldera said: Any way to directly place the switch in UP, MVR or DN? Just bind Up<>Center to the up-position of your 3-way switch, and Down<>Center to the down-position of the 3-way switch, and then once in game it should work exactly as you want. Unless I'm misunderstanding your question? 2 Link to comment Share on other sites More sharing options...
jaylw314 Posted September 5, 2022 Share Posted September 5, 2022 3 hours ago, Caldera said: Any way to directly place the switch in UP, MVR or DN? Thanks in advance, Caldera @Yurgon speaks correctly. The MVR setting corresponds to no button being pressed, and UP and DN correspond to the respective "Flaps Up<>Center" and "Flaps DN<>Center" keybinds. When you start, you might need to cycle the flaps switch to get it in the correct position, or have the "sync HOTAS" option in settings enabled. 2 Link to comment Share on other sites More sharing options...
Caldera Posted September 5, 2022 Author Share Posted September 5, 2022 Thanks! I guess the solution was in front of me the whole time, but I couldn't wrap my brain around it. Caldera Link to comment Share on other sites More sharing options...
Recommended Posts