plau011 Posted September 14, 2022 Share Posted September 14, 2022 Hi all, I have been noticing in DCS when setting up the roll/pitch axis with my CH Fighterstick there is a jiggle in the values. So I go to calibrate and click on the Show Raw Data and see the numbers 0 to 255. I notice a jiggle there. But then also notice if I go up/down/left/right and return to center. When I move left and go back to center the value is 110. When I go right back to center 120 Then front/back 117 and 128. Even with small inputs it does this. Is this normal? Is the jiggle normal? It seems to go between 1 value so probably not too bad. If not would you recommend new pots? Link to comment Share on other sites More sharing options...
Svsmokey Posted September 14, 2022 Share Posted September 14, 2022 (edited) I occasionally sprayed my pots with electronic contact cleaner to solve problems such as this . Don't forget the trim and throttle pots as well . Edited September 14, 2022 by Svsmokey 1 9700k @ stock , Aorus Pro Z390 wifi , 32gb 3200 mhz CL16 , 1tb EVO 970 , MSI RX 6800XT Gaming X TRIO , Seasonic Prime 850w Gold , Coolermaster H500m , Noctua NH-D15S , CH Pro throttle and T50CM2/WarBrD base on Foxxmounts , CH pedals , Reverb G2v2 Link to comment Share on other sites More sharing options...
TonyStovepipe Posted April 20, 2023 Share Posted April 20, 2023 On 9/14/2022 at 6:25 PM, Svsmokey said: I occasionally sprayed my pots with electronic contact cleaner to solve problems such as this . Don't forget the trim and throttle pots as well . I did this on my used fighterstick and it fixed it Link to comment Share on other sites More sharing options...
bfr Posted April 24, 2023 Share Posted April 24, 2023 On 4/20/2023 at 8:29 PM, TonyStovepipe said: I did this on my used fighterstick and it fixed it When I still had CH gear then the pots weren't that hard/expensive to buy new ones for, nor difficult to change over yourself. Link to comment Share on other sites More sharing options...
Phantom_Mark Posted May 16, 2023 Share Posted May 16, 2023 I have the internals of that stick , brand new, never used, I just used the handle and board on my MSFFB2 conversion.......might have some spares which are useful , pots, plastic fittings etc? Link to comment Share on other sites More sharing options...
Recommended Posts