Jump to content

DLC not engaging in Windows 11 EDIT: not a bug, flaps were not going past 50% due to error in controls assignment.


f14billy

Recommended Posts

In windows 11 when flaps are down and throttle isn't MIL pressing the DLC/Countermeasures button won't engage the DLC, instead it deploys countermeasures. Gear up or down does not make a difference. In a windows 10 install it works as expected.

EDIT: not a bug, flaps were not being lowered 100% due to an error in the axis assignment in the controls.

image.jpeg


Edited by f14billy
More information
Link to comment
Share on other sites

3 hours ago, draconus said:

It's not noted as a requirement either in HB's manual nor NATOPS.

from HB F14 Manual:

DLC Direct Lift Control
The DLC or Direct Lift Control is used to control vertical glideslope position without pitch control inputs or engine
throttle commands. The DLC uses the two inboard spoiler sections in conjunction with small corrections on the tail
stabilizers to control lift.
The DLC is engaged by depression of the DLC switch on the control stick with flaps and gear down. This causes the
inboard spoilers to extend to half and enables the DLC & maneuver flap command thumbwheel on the control stick to
control them.
Rotation of the thumbwheel forwards extends the spoilers towards the max up position, decreasing lift and adjusting
glideslope position downward. Rotation of the thumbwheel aft retracts the spoilers towards the flush position,
increasing lift and adjusting glideslope position upward.
Another depression of the DLC switch disengages the system.

4 hours ago, f14billy said:

Since 2.8 when flaps are down and throttle isn't MIL pressing the DLC/Countermeasures button won't engage the DLC, instead it deploys countermeasures. Am I missing something that needs to be done for it to engage?

Here you can find the HB F14 Manaul, most of the useful info are in it.

\Program Files\Eagle Dynamics\DCS World OpenBeta\Mods\aircraft\F14\Docs

To answer your specific question:

Chapter 3. General Design and Systems Overview

Pag.186

DLC Direct Lift Control

 

 

Link to comment
Share on other sites

45 minutes ago, pokeraccio said:

from HB F14 Manual

OK, then pdf is wrong and outdated.

I meant online manual:

http://www.heatblur.se/F-14Manual/general.html#dlc-direct-lift-control

Quote

The DLC is engaged by depression of the DLC switch on the control stick with flaps down and throttles less than MIL.

which is correct.

  • Like 1

🖥️ Win10 i7-10700KF 32GB RTX3060   🥽 Rift S   🕹️ T16000M HOTAS   ✈️ FC3, F-14A/B, F-15E   ⚙️ CA   🚢 SC   🌐 NTTR, PG, Syria

Link to comment
Share on other sites

1 hour ago, draconus said:

OK, then pdf is wrong and outdated.

I meant online manual:

http://www.heatblur.se/F-14Manual/general.html#dlc-direct-lift-control

which is correct.

Now we need to check why natops material is different... or which one of the references is the thruth 🙂 

 

UPDATE:

In DCS F14B the DLC are engaged with Landing Flaps and Thrust lower than MIL, also with the Landing Gear UP, so the PDF manual seems incorrect, I do not have Natops to check it out, but you looked at it, this make sense.


Edited by pokeraccio
tested in game
  • Like 1
Link to comment
Share on other sites

Its clearly stated in NATOPS manual, no gear down is needed for DLC to engage.

 

From F-14B (same for A, only different paragraph no.) NAVAIR 01-F14AAP-1, 2.22.6 Direct Lift Control

During landing approaches, the spoilers and horizontal stabilizers can be controlled simultaneously to provide vertical glidepath
correction without changing engine power setting or angle of attack. Only the inboard spoilers are used for DLC.

Before DLC can be engaged, the following conditions are required:
1. Flaps down greater than 25°.
2. Throttles less than MIL power.
3. Inboard spoilers operational.
4. Pitch B and Yaw B computer segregations operational.
5. Operable combined hydraulic pump.

  • Like 2
Link to comment
Share on other sites

  • f14billy changed the title to DLC not engaging in Windows 11
  • f14billy changed the title to DLC not engaging in Windows 11 EDIT: not a bug, flaps were not going past 50% due to error in controls assignment.
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...