left ddi

[DukeAngus]

is there anyway to acknowledge  and remove the adv line covering the bottom left ddi. when one pops up it blocks the whole bottom of the screen thus blocking important information.

for instance how would i get rid of BIT or FPAS  when they pop up randomly during the mission?

is there any way to get rid of HOME FUEL without tanking?

thank you for taking time to read this post

[Tholozor]

The BIT advisory will display any time a BIT has failed. Open the BIT page and you can see the failed BIT (will be flashing). Press the OSB labeled 'STOP' to acknowledge all failed BITs, and the advisory will be removed.

The FPAS advisory will display any time the FPAS cannot calculate the HOME FUEL caution. Fuel calculations become invalid at Mach 0.9 and above, which is the most common cause that trips the advisory.

The HOME FUEL caution (not an advisory) will trigger when the calculated fuel remaining at the selected home waypoint is at or below 2000 lbs (this is a separate logic to BINGO). The default home waypoint is always set as waypoint 0. You can set the home waypoint to a closer waypoint to clear the caution (provided the calculated remaining fuel is above 2000 lbs). The HOME FUEL caution should reset with the probe extended, weight on wheels, landing gear cycled up-down-up, or the home waypoint changed (for about 5 seconds until the logic kicks back in to recalculate).

[Foka]

But answering to your question - you can not prevent ADV line obscuring part of the display.

[Minsky]

6 hours ago, DukeAngus said:

is there any way to get rid of HOME FUEL without tanking?

FPAS > set HOME to an empty (zeroed) waypoint (e.g. 58).

[DukeAngus]

thank you for the responses