reported Mark in DTOS via TGP break CZ

[falconzx]

Loadout 4xGBU12, Litening.
Steps to reproduce:
-Set DTOS mode
-Designate a point with TMS up (i did it via HMCS)
-DMS down for TGP SOI.
-TMS right (area track) to ground stabilize
-ICP 7(Mark)
-TMS UP x2 to create mark.
-press 0(M-SEL) to select that mark as active STPT
-dobber RTN to exit Mark mode.
-NWS to switch to CCRP
-TMS down to CZ
Here the TGP will CZ to the previous waypoint and not to the active one.

Workaround: Make SOI a different sensor (FCR, HSD) change waypoint then CZ should behave correctly again.

Edited March 3, 2024 by falconzx

[Furiz]

That logic has been corrected in the latest patch.

‪

 

[_SteelFalcon_]

1 hour ago, Furiz said:

That logic has been corrected in the latest patch.

‪

 

That may be, but in CCRP it should CZ back to the active STPT, in this case STP 26 as he made it the current STPT by MARK and M-SEL, then switching to CCRP. at that point he is no longer in DTOS or EO-VIS, therefore CZ should reset to STPT 26.

[Furiz]

40 minutes ago, _SteelFalcon_ said:

That may be, but in CCRP it should CZ back to the active STPT, in this case STP 26 as he made it the current STPT by MARK and M-SEL, then switching to CCRP. at that point he is no longer in DTOS or EO-VIS, therefore CZ should reset to STPT 26.

Right, didn't read well, I managed to reproduce and made a track:

TGP CZ after mk point not returning to selected point.trk

[Hellbat]

I will add more evidence to this.  Same issue fundamentally, but I can get this behaviour when I set a markpoint with Mavericks in VIS mode.  Changing the weapon submode to PRE causes the behaviour described above.  Track attached.

markpoint.trk

[Lord Vader]

Hi all.

I've sent this internally for analysis.

Thanks.