sansul Posted July 18, 2009 Share Posted July 18, 2009 Hi, I've completed most of the training missions, start up, flights, hover etc. all went ok I started the campaign and the 1st mission Fam flight, i just can not get the heli of the ground. rotors are spinning etc but just no lift. I have to be doing something wrong? (i.e do i need to radio in to get something to activate to enable take off?) Spent hours and hours on this so far with no luck!! (I tried hitting the R key, but that resulted in death!) :huh: Cheers for any assistance. Link to comment Share on other sites More sharing options...
slug88 Posted July 18, 2009 Share Posted July 18, 2009 Sounds like you've neglected to set your throttle to AUTO. Press Page Up twice to do this. [sIGPIC][/sIGPIC] Link to comment Share on other sites More sharing options...
EtherealN Posted July 18, 2009 Share Posted July 18, 2009 When moving your collective, ensure that the blade angle-of-attack meter at the lower left of the front panel is moving to indicate that your stick is correctly set up. [sIGPIC][/sIGPIC] Daniel "EtherealN" Agorander | Даниэль "эфирныйн" Агорандер Intel i7 2600K @ 4.4GHz, ASUS Sabertooth P67, 8GB Corsair Vengeance @ 1600MHz, ASUS GTX 560Ti DirectCU II 1GB, Samsung 830series 512GB SSD, Corsair AX850w, two BENQ screens and TM HOTAS Warthog DCS: A-10C Warthog FAQ | DCS: P-51D FAQ | Remember to read the Forum Rules | | | Life of a Game Tester Link to comment Share on other sites More sharing options...
sansul Posted July 19, 2009 Author Share Posted July 19, 2009 throttle to AUTO, done. its like i just have zero lift, i must be missing something BTW, the heli is allready all throttled up and started when you get in with this mission. driving me mad :) Link to comment Share on other sites More sharing options...
Weta43 Posted July 19, 2009 Share Posted July 19, 2009 When you move your "collective" does the in game one move? Cheers. Link to comment Share on other sites More sharing options...
sansul Posted July 19, 2009 Author Share Posted July 19, 2009 blade angle shows 1 degree. whats strange is that if i end the mission and jump to a training mission, say hover, everything works fine. :helpsmilie: Link to comment Share on other sites More sharing options...
sansul Posted July 19, 2009 Author Share Posted July 19, 2009 not sure what i did, but took off! thanks again Link to comment Share on other sites More sharing options...
Recommended Posts