Patch 1.02 ABRIS Bug pls confirm.

[madyogi]

Since two months passed and no one replied to my post, I would like to ask again about confirmation of bug described below.

 

My BS was originally the 1.0.0-en patched to version 1.0.1c-en. Of course, I made the same mistake other people did and installed the 1.0.2 over the 1.0.1c. Fortunately found the "BIG RED LETTERS" post and removed everything – patches, and the entire game. I also located the install directory and removed everything what was left there.

 

Installed a clean 1.0.0-en (boxed version).

Installed the 1.0.2-en patch.

 

 

Game starts fine, doesn't ask about the activation key (finally, already lost 2).

 

 

Steps to reproduce the ABRIS bug:

1. start the mission editor.

2. Put a ka-50 on the runway (Krymsk).

3. Draw few way-points for it.

4. Save the mission and push the test button to do some flying.

5. When on the runway insert new points into the flight path and ACTIVATE the route.

6. Menu->Plan->Select->Save to save a new route into the ABRIS RAM memory. The 'Routes' counter changes from 'NO' to '1' in the ABRIS 'Menu'. These routes are always flashed from memory when ABRIS is restarted.

 

According to manual you can also permanently save own routes to PC's HDD with this:

7. Menu->CTRL->SETUP->DTB->SAVE and load them with "... -> LOAD".

Both doesn't work for me. The top ABRIS menu doesn't change, all entries have a red 'NO' state.

 

I also exited the game, removed the 1.0.2 patch, installed it again, removed entire "<DCS_INSTALL_PATH>/TEMP" directory and started the game.

When lunched the mission created earlier, confirmed that the bug still exists but also found few logs in my "/TEMP/Errors.log", connected to ABRIS. Can anyone point me the way, what to look for inside the *.lua files to fix the ABRIS bugs?

I guess, Load/Save functions were working in training missions (not sure):doh:

Hoping for solution...

Regards to everyone...

Edited July 7, 2010 by madyogi