nightborder Posted February 3, 2011 Share Posted February 3, 2011 Hi all, I have huge problem with my Avi8r-01 joystick in LOFC2. First of all I have win7 64b, and got some driver for the stick, installed it, but I have problems time to time with cross on calibration that isn`t on center, left throtlle slider wont go up to the end, but major problem when i fix calibration issue, is that my plane roll to the left so bad that I cant control it. I menage to trim it to the end, but thats kinda stupid resolving system. I dont have any problems runing LOMAc... anyone can help? Link to comment Share on other sites More sharing options...
nightborder Posted February 3, 2011 Author Share Posted February 3, 2011 anyone? Link to comment Share on other sites More sharing options...
nightborder Posted February 3, 2011 Author Share Posted February 3, 2011 Ok I think its trim problem. I take off with bad roll on left...somehow menage to trim and stabilize aircraft (SU 27).Turned on autopilot, and after autopilot turned off , huge roll on left happened again. Any idea? Is it joystick or software problem? Link to comment Share on other sites More sharing options...
S77th-konkussion Posted February 3, 2011 Share Posted February 3, 2011 Got some driver? What does that mean? Did you install the drivers & SST software? Did you just plug it in? [sIGPIC]http://forums.eagle.ru/attachment.php?attachmentid=43337&d=1287169113[/sIGPIC] Link to comment Share on other sites More sharing options...
104th_Crunch Posted February 3, 2011 Share Posted February 3, 2011 Check the sim settings for the mapping of all axes . Sounds like you have the same axis mapped to more than 1 function. Link to comment Share on other sites More sharing options...
nightborder Posted February 4, 2011 Author Share Posted February 4, 2011 Got some driver? What does that mean? Did you install the drivers & SST software? Did you just plug it in? I have win 7 64b driver for my stick and sst too Link to comment Share on other sites More sharing options...
nightborder Posted February 4, 2011 Author Share Posted February 4, 2011 Check the sim settings for the mapping of all axes . Sounds like you have the same axis mapped to more than 1 function. will do Link to comment Share on other sites More sharing options...
Recommended Posts