[A10C] AUTOPILOT

[bamboa]

BONSOIR Peut on avoir de l'aide ou un tuto pour le pilotage automatique de A10c et pourquoi apres avoir crée unplan de vol dans l'editeur de mission l'avion ne suit pas le plan de vol assignée apres avoir mis sur ALT/HDG OU ALT/PATH :( merci

Edited May 26, 2011 by psycho

[Cahuete]

Le pilote auto est basique (dans le vrais a10 aussi), soit il garde un cap soit une altitude soit un angle de montée ou de descente

[psycho]

Le fonctionnement des 3 modes du pilote auto est décris page 135 du manuel :

 

Autopilot Select Switch. Located along the right side of the panel is a three position switch that allows you to select the active autopilot mode. These autopilot modes form the Low Altitude Autopilot (LAAP) system. The three selections are:

 

* PATH (top position). This mode will attempt to keep the aircraft on its current flight path, represented by the total velocity vector symbol on the HUD. This mode will not engage with a bank angle greater than 10-degrees.

 

* ALT/HDG (middle position). This mode will attempt to maintain the barometric altitude and heading of the aircraft when the mode was activated. This mode will not engage with a bank angle greater than 10-degrees.

 

* ALT (down position). When this mode is engaged, the autopilot will attempt to maintain current bank angle and barometric altitude.

 

Note: The A-10C does not include a route autopilot system that automatically flies the aircraft to a steerpoint or along a loaded flight plan.

Once an autopilot mode is selected, you must press the Autopilot Engage button to activate the mode. You may also press the autopilot engage/disengage left throttle button.

If a control input is commanded while in autopilot, the active autopilot mode will automatically disengage and a ―WARNING, AUTOPILOT‖ message will be heard. You can also disengage autopilot by pressing the Autopilot Engage/Disengage button or left throttle button.