G940 and BS2

[Shake3000]

I'm having trouble getting the G940 ffb trim to work to my liking. I've set everything up the way I had it in BS1 and the stick doesn't accurately hold the trim position.

Also I use the trim/rudder fix macro which basicly presses t continuously along with the rudder keys. This causes the stick to jerk around when trimming when it should go limp.

 

Does anyone have a better setup than mine for BS2? I could post mine but I'm not at home right now. I'm just interested which setups work for you, not troubleshooting mine.

[flanker0ne]

Try to invert the Force Feedback, an to lower the FFB force.

[P1KW]

for an accurate position of the trimmer, select * 20-50% sensitivity in the XY axes.

Below 50%, the trimmer is less accurate.

Above 50% the Joy is too sensitive.

 

collective axis, sensitivity * 50%. (edit)

 

rudder pedals, sensitivity * from 50% to 0%. better close to 0%.

 

(*) sensitivity in the Logitech software

 

Do not change the curves in BS.

 

At Logitech software, FFB Force, 50-75. Do not fight a hard joy.

 

In BS, FF Tune, not swap axis, and Trimmer Force value to 100.

 

Greetings.

Edited March 6, 2012 by P1KW
correction

[jib]

I think there is some sort of keyboard/command input rate difference between BS1 and BS2.

Lots of command on my logitec profile dont work any more unless you press them like 3 times.

Maybe this is causing the different feel with the constant T press macro.