Fishbreath Posted October 9, 2013 Share Posted October 9, 2013 Is there one I can look at to see which state the gun is in? I don't see anything move on the weapons control panel when I toggle it. Black Shark, Harrier, and Hornet pilot Many Words - Serial Fiction | Ka-50 Employment Guide | Ka-50 Avionics Cheat Sheet | Multiplayer Shooting Range Mission Link to comment Share on other sites More sharing options...
guitarxe Posted October 9, 2013 Share Posted October 9, 2013 It's this switch circled in red. It's has two states - on and off. 1 Link to comment Share on other sites More sharing options...
Alireza.kh Posted October 10, 2013 Share Posted October 10, 2013 it is hidden , left corner of wcs panel , use middle mouse button to see it . Link to comment Share on other sites More sharing options...
enigma6584 Posted May 13, 2014 Share Posted May 13, 2014 Does this actually work? I don't think I've noticed any difference in rate of fire. Link to comment Share on other sites More sharing options...
Dr_Arrow Posted May 13, 2014 Share Posted May 13, 2014 Does this actually work? I don't think I've noticed any difference in rate of fire. It works indeed, if the switch is set to cut, it will only allow a short burst per trigger press. If it is set to off, you can fire all the rounds in a single burst with one long trigger press. It doesn't set the rate of fire. Link to comment Share on other sites More sharing options...
enigma6584 Posted May 13, 2014 Share Posted May 13, 2014 It works indeed, if the switch is set to cut, it will only allow a short burst per trigger press. If it is set to off, you can fire all the rounds in a single burst with one long trigger press. It doesn't set the rate of fire. Ah, I see. I take it then that the "up" position is the "on" position? Link to comment Share on other sites More sharing options...
Dr_Arrow Posted May 14, 2014 Share Posted May 14, 2014 Ah, I see. I take it then that the "up" position is the "on" position? Yes, up position is the default "on" - burst cut position. Link to comment Share on other sites More sharing options...
enigma6584 Posted May 14, 2014 Share Posted May 14, 2014 Thank you very much. :) Link to comment Share on other sites More sharing options...
YogiNature Posted April 14, 2022 Share Posted April 14, 2022 I just started learning these and those. thanks a lot. Link to comment Share on other sites More sharing options...
Recommended Posts