delcamp36 Posted November 19, 2013 Share Posted November 19, 2013 I am trying to fly the A10-C mission The serpents tail. I would like to use CBU 105's but when I setup the profiles I get an 'invalid fuzing' message appearing on the HUD. I can fly another mission using the same parameters and all is fine. Is it just the mission is not upto date. Thanks for any help. Link to comment Share on other sites More sharing options...
Mosley Posted November 19, 2013 Share Posted November 19, 2013 Just a guess but if you are flying to low I think you will get invalid fuzing. If the HOF is set at 1500 for the cbu105 and you are below it you will get the above error msg. Decrease the HOF or fly a little higher and see if this fixes the problem. i7 2600k @ 4.4 / GTX 470 1.3gb / 8GB DDR3 1600 / TM Warthog #7440 / Toshiba 37" 1080p / OCZ Vertex3 SSD 128GB / Win7-64 / TIR4 Link to comment Share on other sites More sharing options...
delcamp36 Posted November 19, 2013 Author Share Posted November 19, 2013 OK thanks I will try that as I was at a low altitude. Link to comment Share on other sites More sharing options...
AtaliaA1 Posted November 19, 2013 Share Posted November 19, 2013 OK thanks I will try that as I was at a low altitude. The fuse can be adjusted in DSMS also. Button 7 or 8 I think. This was a Boutique Builder iBuypower rig. Until I got the tinker bug again i7 920 @3.6Mhz 12Gig Corsair XMS3 ram 1600 Nvidia 760 SLi w/4Gig DDR5 Ram Intel 310 SSD HDD 160 Gb + Western Digital 4Terabyte HDD Creative SB X-Fi HD Audio Logitech X-530 5.1 Surround Speaker System Dual Acer 32"Monitors. PSU 1200 w Thermaltake Win10 64Bit. Link to comment Share on other sites More sharing options...
Doughboy Posted November 19, 2013 Share Posted November 19, 2013 DSMS Inventory Select station CBU Select the applicable CBU Change HOF (and RPM if non-WCMD) Load or Load Symmetrical if mirrored station is configured the same. Go Ugly Early! [sIGPIC][/sIGPIC] Link to comment Share on other sites More sharing options...
Recommended Posts