chardly38

I decided to reinstall the bios version 2203 that was installed when I got the motherboard form the update on the back of the board. Now the computer will start in to windows. I am updating DCS now and will see how this goes.

I reinstalled the ram. No good. Yes after the bios update the computer would start. I played DCS several times. I was updating DCS to the lates version and the computer appeared to go to sleep (that setting is turned off) then this happened. It has done it once before but i was able to get the computer back on.

Ive had this computer for 3 years. Nothing has changed but Windows 11 and a bios update. I cant get in to bios. Wont load. K have had no problems until this Install.

This Sucks. After this 11 install, bios update. I was updating DCS and thought my computer went to sleep. NO. Now at startup the computer boots then shuts down 3 times then starts and gives me a 55 code. During the shut downs I get a 52 code. That it stuck on 55 code. Asus ROG STRIX Z590-E I7 with EVGA 3080. This is not good. Where do I start.

no just xmp in uefi. If you have any suggestion on what. Im glad it apply them

Well I did a fresh install and now I have shutters that was never there in 10. Frustrating.

Yes All my files are backup.

I have done a Fresh install to Windows 11. My DCS is on a different drive. Should I reinstall DCS going from Windows 10 to 11. I know the DSC application in the bin folder can be used for a short cut. I want to make sure there will be no issues.

I found my mistake. I didnt select 1x3

I just updated from Windows 10 to 11. Now when I go to set up Surround it will only allow me to select two monitors. In the setup multiple display i can see all four monitors. Does anyone have a solution to this beside going back to Windows 10. EVGA 3080

Thanks. I will try some tuning if that does not work that a fresh install is in the feature.

Not sure the correct log but here dcs.log.old

I just updated from Windows 10 to 11. now Im having some performace issues that did not exist before. Should I have done a fresh install. Any suggestions?

I never had consent to fire bound to anything.

From a cold start the menu states. No power in red. This is what I get. There is no command to start. I fly from the pilot seat only. I use George to find me targets so I can engage them. So this update removes the players ability to startup form the pilot seat and have George work?