Profisim1

Well, the bluetooth device may disconnect due to a bad signal for only a few seconds and then continue to operate normally. The point is that RSMapper will crash completely after a disconnect event. And this will also stop other (wired)devices actions that I have set up via RSMapper. The expected behavior would be to disable disconnected device and the actions associated with it, but the program itself should continue to run with other devices.

Hi, first of all thank you for a great program. Is there any donate option? If the following bug could be fixed, it would be great: I have a controller connected via bluetooth, everything works fine. However, if the controller is disconnected (eg weak bluetooth signal, low battery), then RSmapper will crash. Thanks!