dennisVDM

Is there a way to swich an axis from axis to buttons with a single button press or do I need to switch it in simapp all the time? reason: in the F16 the axis is too sensitive and there I have it in button mode, but when I want to fly the ah64d I need that axis again since there is no alternative thanks

and after the update, it reappeared.... hope I can make it go away again

no, because it wasn't assigned to axis. restarting DCS with the throttle (and button) unplugged, then pluging it back in after dcs had loaded, did the trick

not a ministick. even deleted all the RDR left keybinds and still it goes left...even worse as before now. UPDATE: I unplugged my throttle (eventhough I had deleted the binds for RDR on it) and restarted DCS with the throttle unplugged. Then I plugged it in and everything works fine now. even when I rebinded it

same problem here sometimes. rdr moves to the left on it's own. doesn't happen all the time

found the culprit (i think): the VR controller. when switched on it would somehow block the controls. I disabled it completely in the keybinds

corrected above. same problem, will have to wait for update

I was advised to do a repair and it is still happening

no external app. Here's where it gets really weird. When I'm in cockpit view and I push the stick all the way in one direction, the plane moves a few degrees in that direction and stops (as above), BUT, when I switch to outside view, keeping the pressure on the stick, the plane moves smoothly and continues to move...until I witch to cockpit mode, there it stops again. I'll make a video

no external app. Here's where it gets really weird. When I'm in cockpit view and I push the stick all the way in one direction, the plane moves a few degrees in that direction and stops (as above), BUT, when I switch to outside view, keeping the pressure on the stick, the plane moves smoothly and continues to move...until I witch to cockpit mode, there it stops again. I'll make a video

when I start my pc, get into a game of DCS, my VKB gunfighter mk3 stick acts normal. BUT when I have to restart DCS, it acts weird. When I pull up the plane, it will pull up for 10° and stop (eventhough I keep pulling), then I have to go back to center and pull again to cntinue a turn/ climb. Almost as if the stick would react like a keystroke. Again, it works perfectly on the first run, but only restarts of the dccs program lead to this. any ideas?

thanks

I noticed last night that beta players seem to have different servers than stable. Why?? is there a way to have both? I use stable to prevent beta-errors